Qlima PG 101 Instrucciones De Uso página 26

Warning: If any burner fails to ignite, turn the control knob off (clockwise) and also turn the
cylinder valve off. Wait five minutes before attempting to relight with ignition sequence.
After use, close the gas supply by either turning 'OFF' the switch on the regulator or turning
'OFF' the cylinder valve.
In the event of light back whilst the appliance is in use. Turn all the controls, cylinder valve
and regulator switch to the 'OFF' position. Wait 5 minutes before attempting to relight the
appliance. If the problem persists after relighting, consult your gas dealer, or the store where
you purchased the barbecue, or a qualified gas engineer for assistance or repair. Never try to
rectify the problem yourself as this could result in serious injury and/or property damage.
Clean the appliance of excess fat, before storage, with a damp cloth using a mild detergent
solution as the cleaning agent.
Store the appliance in a clean dry environment.
Do not store your gas cylinder indoors. Store in a well ventilated area away from direct sun-
light.
CONNECTING THE GAS CYLINDER TO THE APPLIANCE
This appliance is only suitable for use with low-pressure butane ,propane or their mixture gas
and used with the appropriate low-pressure regulator via a flexible hose. The hose should be
secured to the regulator and the appliance with hose clips.
•
•
•
•
•
Please consult your LPG dealer for information regarding a suitable regulator for the gas cylin-
der.
TO CHECK FOR LEAKS
•
•
•
•
•
•
REGULATOR AND HOSE
•
•
4
26
man_PG 101 ('17).indd 26
Using 28mbar regulator with category I3+ for butane gas and a 37mbar regulator with
category I3+ for propane gas;
Using a 30mbar regulator with category I3B/P(30);
Using a 37mbar regulator with category I3B/P(37);
Using a 50mbar regulator with category I3B/P(50);
Use a suitable regulator certified to BSEN 12864:2001.
BEFORE USE PLEASE CHECK FOR LEAKS
Never check for leaks with a naked flame, always use a soapy
Make 2-3 fluid ounces of leak detecting solution by mixing one part washing up liquid
with 3 parts water.
Ensure the control valve is "OFF".
Connect the regulator to the cylinder and connect regulator with hose and outdoor gas
grill, ensure the connections are secure then turn ON the gas.
Brush the soapy solution on to the hose and all joints. If bubbles appear you have a leak,
which must be rectified before use.Turn off the gas supply in the event of gas leak.
Retest after fixing the fault. Turn OFF the gas at the cylinder after testing.
If detected leakage can not be rectified, do not attempt to cure leakage but consult your
gas dealer.
Use only regulators and hose approved for LPG at the above pressures (See Page 2). The
life expectancy of the regulator is estimated as 10 years. It is recommended that the regu-
lator is changed within 10 years of the date of manufacture.
The use of the wrong regulator or hose is unsafe; always check that you have the correct
items before operating the barbecue.
water solution
16-02-17 15:09