Premier ED-4876 Manual De Instrucciones página 10

KEY
PRIOR TO FIRST USE
Before using your travel kettle for the first time (or following a long period without use ),it should be
boiled 3 times .
1 . Read the safety instructions through carefully .
2 . Ensure that the cord is fully extended .
3. Remove the extra accessories from inside the kettle .
4. Check that the switch (13) on the underside of the kettle is set to the correct supply voltage .
5. Fill the kettle with water up to themaximum filling level (MAX) .
6. Pour out the water once it has boiled.
Repeat the process described under points 5-6 three times .
USING YOUR ELECTRIC TRAVEL KETTLE
1. Remove the lid (6) of your travel kettle by depressing the Button on the lid (5) while pulling the lid up.
2. Remove the extra accessories from inside the kettle .
3. Check that the switch (13) on the underside of the kettle is set to the correct supply voltage .
4. Pour fresh water into the kettle . The kettle must be filled to the MIN mark at least, but no higher than
the MAX mark .
5. Plug the kettle in and check that it is switched on .
6. Press the On switch (2) . The red indicator light (14) comes on and the kettle begins to heat up the
water .The water will boil within a few minutes, depending on the amount of water in the kettle. If you
want to halt the boiling , switch off at the wall socket and unplug . Once the water is boiling , the kettle
will automatically switch off thanks to the integrated thermostat . A click will be heard from the On switch,
and the indicator light will go out .
1. Electric travel kettle
2. On switch
3. Storage space for teaspoon
4. Handle
5. Button for opening lid
6. Lid
7. Cap for storage space
8. Temperature controller
9. Teaspoon
10. Lid for storage container
11. Storage container for tea and coffee
12. Cups
13. Switch 110V/220V (on
14. Indicator light
the bottom)
P-3