Troubleshooting - Skytec SPJ-PA912 Manual De Instrucciones

Troubleshooting

One certain method of determining if a speaker is faulty is to substitute a speaker that is known to work correctly for
the suspected problem speaker. If the "normally correct speaker" is experiencing the same difficulties or problems
as the suspected problem speaker, use the information below to isolate the problem.
Problem Possible cause
No output
Cables
Intermittent
Poor connections
Constant noise, Faulty electronic
buzzing and/or
humming
Poor low-
Improper polarity
frequency output
Action
Reseat all connectors
Substitute known good cables
Check solder joins
Inspect cable for damage
Inspect wire or connector for stray strand that may short
While it is possible for a faulty speaker to exhibit intermittent output,
it's more likely that an output cable/connector is the problem. Check
the soldering on your connectors.
Any constant noise originates in the amplifier, mixer, signal
processing, source device in the signal devices, or line-level wiring.
Check and correct system grounding as required. Chain check for
noisy sources or electronic components. Check wiring for shielding.
When two speakers in close proximity to each other are connected
out-of-polarity, they can partially cancel each other out, especially at
low frequencies. Check your speaker cables to be sure they are all
identically wired and connected. Check the balanced line signal
cables to be sure they are all correctly wired.
9