TECshow NAVIGATOR 2 Manual De Usuario página 10

Delete Scene
1) Locate the scene in the program BANK. Use BANK
UP/DOWN to navigate program banks.
2) Press and hold the AUTO/DEL button while press-
ing the SCENE you want to delete.
Delete All Scenes
1) Press and hold the PROGRAM button and the
BANK while you turn the controller Off.
Bank Copy
1) Press the PROGRAM button for 3 seconds.
2) Locate the program BANK. Use BANK UP/DOWN
to navigate program banks.
3) Press and release the MIDI/ADD button.
4) Locate the destination program BANK. Use BANK
UP/DOWN to navigate program banks.
5) Press the MUSIC/BANK-COPY button to compete
copy.
Bank Delete
1) Press and hold the PROGRAM button for 3 sec-
onds.
2) Locate the BANK to delete. Press the AUTO/DEL
and MUSIC/BANK-COPY at the same time to delete
the Bank.
Chase Programming
A chase is created by using previously created scenes.
Scenes become steps in a chase and can be arranged
in any order you choose. It is highly recommended
that prior to programming chases for the first time;
you delete all chases from memory. See "Delete All
Chases" for instructions.
P. 10
Tecshow Navigator 2 | English version
Create a Chase
A Chase can contain 240 scenes as steps. The term
steps and scenes are used interchangeably.
1) Press and hold the PROGRAM button for 3 sec-
onds.
2) Press the CHASE (1~6) button you wish to pro-
gram.
3) Change BANK if necessary to locate a scene.
4) Select the SCENE to insert.
5) Tap the MIDI/ADD button to store. All LED's will
flash 3 times.
6) Repeat steps 3 ~ 5 to add additional steps in the
chase. Up to 240 steps can be recorded.
7) Press and hold the PROGRAM button for 3 sec-
onds to save the chase.
Copy Bank into Chase
1) Press and hold the PROGRAM button for 3 seconds
to enter programming mode.
2) Select the BANK to be copied using the BANK UP/
DOWN buttons.
3) Press MUSIC/BANK COPY and Midi/Add buttons at
the same time to copy.
4) Press and hold the PROGRAM button for 3 seconds
to exit programming mode.
Adding a Step to a Chase
1) Press and hold the PROGRAM button for 3 seconds
to enter programming mode.
2) Press the desired CHASE (1~6) button.
3) Press the TAPSYNC/Display and the display will
display the scene and bank number. This displays the
scene you will be adding (STEP LED must be on),
4) Use the BANK UP/DOWN buttons to scroll through
the chase and arrive at the step number for which you
would like to add or append a scene/step to.
5) Press MIDI/ADD button and one step number will
be added to the previously displayed step number.
6) Press the SCENE button that corresponds to the
scene to be copied.
7) Press MIDI/ADD button again to add the new step.