DeWalt DCB412 Manual De Instrucciones página 7

3. Route and secure the charger cord in a manner that keeps it from
moving, away from sharp edges, pinching and away from vehicle
heat sources.
4. Do not modify the charger cord or 12-volt power ring terminal
adapter and do not modify the vehicles wiring harness in any way.
5. The charge indicator light will start to blink. Refer to Indicator Light
Operation.
6. If charger does not turn on, check fuse located in plastic box near
ring terminals. To access, pull off plastic top. Use replacement fuse
of identical type and rating (10 amps). When reassembling, be sure
plastic top is securely reinstalled. If fuse continues to blow, take
charger to a certified service center.
NOTICE: To prevent excessive discharge of the vehicle battery, do not
charge battery pack without operating the vehicle.
Charging Procedure (Fig. 4)
1. Plug the charger into an appropriate
outlet before inserting the battery pack.
2. Insert the battery pack into the charger,
as shown in Figure 2, making sure the
pack is fully seated in charger. The red
(charging) light will blink continuously,
indicating that the charging process
has started.
3. The completion of charge will be
indicated by the red light remaining
ON continuously. The pack is fully
charged and may be used at this
time or left in the charger.
4. The indicator light will remain on for an additional 24 hours while the
charger maintains your battery pack in a fully charged condition.
5. After 24 hours, the charger will shut off automatically to reduce the
amount of energy drained from the vehicle's battery.
6. The indicator light may stay on momentarily after the battery pack is
NOTICE: To prevent excessive discharge of the vehicle battery, do not
charge more than one battery pack without operating the vehicle.
Indicator Light Operation
x
Charge Indicators
FIG. 4
Some chargers are designed to detect certain problems that can
arise with battery packs. Problems are indicated by the red light
flashing at a fast rate. If this occurs, re-insert battery pack into
the charger. If the problem persists, try a different battery pack to
determine if the charger is OK. If the new pack charges correctly,
then the original pack is defective and should be returned to a service
center or other collection site for recycling. If the new battery pack
elicits the same trouble indication as the original, have the charger
tested at an authorized service center.
HOT/COLD PACK DELAY
Some chargers have a Hot/Cold Pack Delay feature: when the
charger detects a battery that is hot, it automatically starts a Hot Pack
Delay, suspending charging until the battery has cooled. After the
battery has cooled, the charger automatically switches to the Pack
Charging mode. This feature ensures maximum battery life. The red
light flashes long, then short while in the Hot/Cold Pack Delay mode.
5
removed from the charger. ALWAYS wait for the indicator light to go
out before inserting another pack.
PACK CHARGING
PACK CHARGED
HOT/COLD DELAY
PROBLEM PACK OR CHARGER
PROBLEM POWERLINE