Perel Tools AAC01 Manual Del Usuario página 3

AAC01 – AIR COMPRESSOR WITH GAUGE AND WORK LIGHT
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the AAC01! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
3. General Guidelines
• Do not operate or place the device near flammable materials.
• The device is water-resistant but not waterproof. It may be damaged if submerged in water.
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
4. Description
1. ON/OFF switch
2. adjustable work light
3. air hose
4. quick-connect chuck
5. reading gauge
5. Use
• Connect the power cord into your 12V power source (cigarette lighter socket).
• Push the chuck (4) of the air hose (3) onto the air valve of the tyre and close the thumb latch.
• Turn the ON/OFF switch to mode II.
• Monitor the pressure gauge (5) while inflating.
• When the appropriate pressure has been reached, turn off the device and disconnect the hose.
• To inflate other articles, insert the proper needle into the connector and close the thumb latch. Insert the needle
into the item to be inflated and repeat the above steps.
AAC01
- 3 -
PEREL