Noise Gate - FONESTAR FCS-10101D Manual De Instrucciones

EN
EQUALIZATION
This parameter allows certain frequencies to be enhanced or attenuated in order to improve sound quality
and avoid any potential internal mode problems.
This column allows you to fine-tune the equalization curve, either by a graphical representation of the
frequencies, or by frequency band, using the BASS (low frequencies) and TREBLE (high frequencies) settings.

NOISE GATE

These columns have a noise gate, a compressor that improves the dynamics of the signal and allows a
threshold to be determined from which no sound shall penetrate through.
This allows a minimum signal level to be determined, beyond which it is amplified and reproduced by the
loudspeakers. This is useful in situations in which background noise is present and you only wish to capture
the voice of the presenter, such as at public events, liturgies, etc.
CONTROLS AND FUNCTIONS
REAR PANEL
1.- CONTROL: D9 connector for connection to the control unit mod. FCS-RC01.
2.- SIGNAL OUTPUT: 300 mV unbalanced line output, male XLR connector .
3.- SIGNAL INPUT: 300 mV unbalanced line output, female XLR connector.
4.- 100 V SIGNAL IN: 100 V line input. For connection of an amplifier with 100 V line speaker output.
5.- GND: ground (earth) terminal.
6.- Technical service reserved.
7.- POWER: sound column on/off switch.
8.- Power supply socket.
- 3 -