Installation Instructions; Safety Instructions; Wiring Diagram - Truma CP V Instrucciones De Uso

Installation instructions

Safety instructions

Only qualified technicians may assemble and connect electri-
cal devices!
Ensure that the power supply has been disconnected! Discon-
nect the mains plug!
Only use the supplied parts and the specified cable cross-sec-
tions and fuses to connect the device!
Only use suitable and fully functional tools.
Only wire the device as specified in the supplied wiring
diagram!
Installation
Installation in vehicles must accord with the technical and
administrative provisions of the individual country of use
(e.g. EN 1648). The national legislation and regulations must
be observed.
In other countries always observe the respectively valid
regulations.
Remove the equipment pack (accessories) and check it is
complete:
1 Instructions for installation and use
4 Mounting screws
1 Measuring cable set for two batteries, 5 m long
Install the panel in a place that is protected from damp and wet.
Prepare an installation opening for the device.
80
R 4
88
All dimensions in mm.

Wiring diagram

BU = blue
RD = red
PK = pink
The fuses must be attached close to the positive terminals of
the batteries.
Connection
Before connecting or disconnecting the cables, the
supply lines to the battery and mains supply must be
disconnected! Only use the specified cable cross-sections and
fuses of the correct strength!
– Connect the measuring cable to the batteries according to
the wiring diagram.
– Insert the 3-pin plug of the measuring cable to the device.
– Attach the device with the supplied screws.
Dia 1.5
CP V
14,0
13,5
13,0
12,5
12,0
11,5
Volt
11,0
I
< _ 10,5
Battery
Made in Germany
3-pol
II
5