Peg-Perego aria oh Instrucciones De Uso página 10

EN_English
Thank you for choosing a
Peg-Pérego product.
WARNING
• CAREFULLY READ INSTRUCTIONS
AND KEEP FOR FUTURE USE.
THE CHILD'S SAFETY COULD BE
PUT AT RISK IF THE INSTRUCTIONS
ARE NOT FOLLOWED.
• THIS PRODUCT IS DESIGNED
FOR A CHILD WHOSE MAXIMUM
WEIGHT IS 45 POUNDS (20 KG)
AND WHOSE MAXIMUM HEIGHT
IS 43 INCHES (110 CM). THIS
SHOPPER BASKET IS DESIGNED TO
CARRY A MAXIMUM WEIGHT OF 11
POUNDS (5 KG). ANY CUPHOLDER
EVENTUALLY PROVIDED WITH
THIS UNIT IS DESIGNED TO CARRY
A MAXIMUM WEIGHT SPECIFIED
ON THE CUPHOLDER ITSELF. ANY
POACH OR POCKET PROVIDED
WITH THIS UNIT IS DESIGNED TO
CARRY A MAXIMUM WEIGHT OF
0.44 POUNDS (0.2 KG).
• FAILURE TO FOLLOW
MANUFACTURER'S SPECIFICATIONS
OR USE OF ACCESSORIES OTHER
THAN THOSE APPROVED BY THE
MANUFACTURER MAY CAUSE THE
UNIT TO BECOME UNSTABLE.
• AVOID SERIOUS INJURY FROM
FALLING OR SLIDING OUT. ALWAYS
USE COMPLETE 5 POINT SEAT BELT.
• NEVER LEAVE YOUR CHILD
UNATTENDED.
• ALWAYS USE ALL THE BRAKES
WHENEVER PARKED.
• TO AVOID SERIOUS INJURY, WHEN
MAKING ADJUSTMENTS ENSURE
THE CHILD'S BODY IS CLEAR OF
ALL MOVING PARTS.
• ALL OPERATING AND ASSEMBLY
PROCEDURES SHOULD BE
PERFORMED BY AN ADULT.
• DO NOT LIFT THE STROLLER BY
GRIPPING THE FRONT BAR. THE
FRONT BAR IS NOT DESIGNED TO
WITHSTAND LOADS.
• ENSURE THAT THE STROLLER IS
OPENED CORRECTLY AND LOCKED
IN POSITION OF USE.
• CHECK TO MAKE SURE THAT THE
CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).
• DO NOT DRIVE THIS PRODUCT
AROUND STAIRS OR STEPS; CARE
MUST BE TAKEN IF UNIT IS USED ON
STAIRS OR ESCALATORS.
• DO NOT USE THE PRODUCT IF IT
HAS BROKEN OR MISSING PARTS.
• DO NOT USE NEAR FIRE OR
EXPOSED FLAME.
• NOTICE: THIS ARTICLE MEETS OR
EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833 STANDARD
AND LATEST REVISIONS.
instructions for use
OPENING THE STROLLER
1• To open the stroller, pull the small lever (1) on
the handlebar and simultaneously press the
handle (2), as shown in the figure.
2• Firmly lift the handlebar upwards, then push
downwards until it clicks into place.
STROLLER ASSEMBLY
3• Take care to mount the two wheels fitted
with brakes on the rear of the stroller. Fit the
wheel, push button A while pushing the wheel
further until you hear the final click: the wheel
is securely fastened.
4• To mount the front wheels, push down lever A,
then slide on the wheel till it clicks.
5• Attach the front bar as shown in the fi gure.
HOOD
6• To attach the hood, insert the tabs into the
special notches.
7• Fasten the hood to the back of the backrest,
and press down on the side braces as shown in
the figure.
8• To remove the hood, press the side buttons
while lifting the hood off, as shown in the
figure.
9• The hood can be moved to different positions
while your child is sleeping, as shown in the