Led Indication; Safety Precautions - König Electronic CMP-MOBDOCK50 Manual De Uso

Press the power button. The Mode LED will go on.
Once both drives are installed, press the "duplicate start" button. The mode LED will be flashing, wait for
5 seconds; the mode LED will go out and then press the start button again to confirm the duplication process.
You will see the HDD's active LED flashing until the whole duplication is complete. When the duplication is
successfully finished, all the LEDs go out.

LED indication

Safety precautions:

Maintenance:
Clean only with a dry cloth. Do not use cleaning solvents or abrasives.
Warranty:
No guarantee or liability can be accepted for any changes and modifications of the product or damage caused
due to incorrect use of this product.
General:
Designs and specifications are subject to change without notice.
All logos brands and product names are trademarks or registered trademarks of their respective holders and
are hereby recognized as such.
Keep this manual and packaging for future reference.
Attention:
This product is marked with this symbol. It means that used electrical and electronic products should
not be mixed with general household waste. There is a separate collections system for these products.
To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
3
Power
Target HDD
Source HDD
Power