installation.
All components must remain accessible.
The ambient temperature must not exceed 40 ºC.
Standards and guidelines
If installed and used as intended, the light and the
respective transformer fulfill the standards EN 60598-
2-2 / EN 60335-2-105 as well as the low voltage and
EMC guidelines.
Technical Data
Light
Nominal voltage:
Power:
Protection class:
Serial number:
Dimensions:
weight:
transformer
Input (IN): 100 – 240 V / 50 – 60 Hz / 70 – 170 mA
Output (OUT):
Protection class:
Serial number:
Dimensions:
weight:
The transformer must not be installed in protection zones
0, 1 or 2.
The transformer must be installed inside the wall in a
socket. This socket inside the wall is connected to the
light via an empty conduit EN 20.
The specifications are identical to the data on the type
plate for the light and the transformer.
Fault
Light does not light up
12 V DC / 50 Hz SELV
3 W
IP X5
40871000 (see typeplate)
see page 60
739 g
12 V DC / 500 mA
IP 20
19769610 (see typeplate)
see page 60
81 g
Cause
- No mains power
- Transformer defective
- Illuminant defective
Connecting cable between light/transform
Cable length:
Wire cross section:
– Wire color:
+ Wire color:
Protection type of plug to the light:
Connection on the transformer:
Empty conduit for cable:
If the connecting cable is shortened, it must be fitted with
0.25 mm² wire end plugs and a contact length of 8 mm.
Cleaning / Repair
Cleaning recommendations, see enclosed brochure.
Illuminant change
Any work may only be carried out in a de-energized
state. Here, the voltage supply must be safely separated
via the main switch or mains plugs.
The operator can perform the illuminant change.
Illuminant (3,6 W / 0,3 A / 3200 K)
Order number: 95465000
Illuminant change see page 63
All spare parts must be purchased at the dealer's.
Remedy
- Check input/output voltage of the
transformers
- Replace transformer
- Replace illuminant
7 m
approx. 0,25 mm²
black (GND)
red (12 V DC)
IP 68
Clamp connection
EN 20