Publicidad
STEP 2 - FRAME INSTALLATION
The drawer fronts are packed separately. Do not unpack them until the room is clear of hazards.
1. Mark the height for the vanity frame install on the finished wall and install two of the #10 x 2" screws (SS674) at the locations shown
in Figure 1. Do not install tight to the wall, leave 1/8" behind the head.
2. Place the vanity frame on the screws using the top left and right keyholes. See Figure 2. The keyhole on the left allows for up and
down adjustment.
WARNING: THESE SCREWS ARE NOT THE FINAL SUPPORT FOR THE VANITY! SEE NEXT PAGE FOR FINAL BOLT UP.
1
2
© 2017 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Installation instructions
Recommended vanity height
34-1/2"
(876 mm)
24" = 10"
(254 mm)
30" = 13"
(330 mm)
36" = 16"
(406 mm)
C L
5
2-1/2"
(64 mm)
[SS674]
(2) #10 x 2" Screw
Part no. 209-1274-rA rev. 06/16/17
Curated Cartesian H2
Publicidad
Capítulos
