Before Use; Operation - cecotec Bamba PRECISIONCARE Manual De Instrucciones

ENGLISH

3. BEFORE USE

1. Take the product out of the box.
2. Remove all packaging materials. Keep the original box.
3. Make sure all the components are included and in good conditions, otherwise,
contact immediately the official Technical Support Service of Cecotec.
4. Oil the device's blades before the first use.

4. OPERATION

• Connect the device to a power supply.
• Turn on the clipper with the on/off switch.
Note: An audible click may sometimes be heard when switching the equipment on, it
is a result of the drive unit switching on. This is completely normal.
How to adjust the blade fixing screw
The blades are fixed to the optimum position during manufacturing. Despite this, it
can be modified due to voltage fluctuations. Use the blade fixing screw to reposition
the blades at the desired position if necessary.
1. Switch the clipper on.
2. Turn the adjustment screw clockwise until you hear a noise.
PRECISIONCARE PROCLIPPER TITANIUM GO
14
3. Turn the adjustment screw anticlockwise until the noise stops. That is the
optimum position.
How to change or readjust the blades
1. Turn off and disconnect the appliance from the power supply.
2. Undo both screws on the cutting unit, remove the bottom and top blade.
3. When assembling them back, both should be aligned. Ensure:
- Adjust the blade lever to the shortest cutting length.
- The distance between the front edge of the bottom blade and the front edge
of the top blade should be between 0.8 mm and 1.5 mm.
- The bottom and top blade should be positioned parallel to each other.
4. The first tooth of the top blade (from the left) must cover the first tooth of the
bottom blade.
5. The top-right tooth of the top blade must touch the top-right large tooth of
the bottom blade.
6. Tighten both screws.