Technical Specifications - Weelko MELTY WKE005 Manual De Instrucciones

OPERATION
1. Put the paraffin into the warmer.
2. Turn the switch "hi" to melt the
paraffin.
3. When the paraffin melts, turn on
the switch "lo". Once the temperature
decreases, check the temperature with
your hand to see if it is proper to start the
treatment. Make sure it is not as high as
to become uncomfortable for the patient.
HAND CARE
RECOMMENDATIONS
1. Wash your hands and remove all
the accessories you wear.
2. Use the finger to check the para-
ffin temperature.
3. Extend the whole palm into the
paraffin for 4-6 times shortly for a 2-3
seconds contact. Then you will get a thick
film on your hand.
4. Put on plastic gloves to make sure
that you keep the temperature of your
hands so as to help the skin to absorb the
nutrients. Take the gloves off after 15-20
minutes.
5. Slowly remove the paraffin film
from the hands and clean them carefully.
The skin will become smooth and delica-
te.
FOOT CARE
EN
RECOMMENDATIONS
1. Wash the feet previously to the
treatment.
2. Use the finger to check the para-
ffin temperature.
3. Put the feet into the paraffin 4-6
times shortly for a 2-3 seconds contact.
If the feet are too big to put them into
the container, you should use the brush
to apply the wax on the feet. Once the
paraffin forms a film on the feet, use a
plastic bag to cover the whole feet in
order to keep the temperature for around
15 minutes.
4. Slowly remove the paraffin film
from the feet and clean them carefully.
The foot skin will become smooth and
delicate

TECHNICAL SPECIFICATIONS

MELTING TEMPERATU-
RE
MAINTENANCE TEM-
PERATURE
CAPACITÉ
RATED POWER
RATED VOLTAGE
65ºC
55ºC
2700 ml
150W
AC 220V ~ 240V
© 2020 Weelko
www.weelko.com
Importer: Weelko Barcelona, S.L.
ESB65397556