Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
04
CHARGING THE POWER BANK & CHARGING YOUR DEVICE & OPERATING THE LED FLASHLIGHT
How to charge the power bank
Connect the Power bank to a USB Wall or Car adapter using the Micro-USB charging cable provided. Once
plugged in correctly the Power bank will automatically start charging.
*Note: For fastest charging of the power bank use a 5V – 2A power supply.
• To fully charge the power bank: Let charge until all 4 LEDs are lit. This can take up to 4 hours with a 2 amp
power supply or 7 hours with a 1 amp power supply.
One LED indicates up to 25% charge, two LEDs up to 50%, 3 LEDs up to 75%, 4 LEDs 100%.
How to use power bank to charge your device
For devices with a micro USB port use the included cable. For devices that use Lightning or USB-C the cable
is not included. Connect the USB A (larger plug) into one of the two output ports, connect the other end to your
device. Your device will start charging automaticaly.
*NOTE: The power bank will shut down after 30 seconds if left idle (no devices plugged in)
Operating the LED flashlight
The light function cycles as follows: High power -> Low power -> Strobe -> Off
Each quick press of the power button changes to the next function
For the SOS function, long press at anytime to activate, press again to turn the light off
Battery type:
Li-polymer
Capacity:
6000mAh
Flashlight
0.06W x 18
Lumens 216
Input:
Micro USB 5V/2A
Output:
USB1 5V/2.1A
USB2 5V/1A
Operating Temperature:
0-45ºC
Micro USB charging cable:
1.5ft (45cm) cable
SPECIFICATIONS
05
Publicidad
Tabla de contenido
