VOX electronics DPS-6220 Manual De Usuario página 6

f) Adjust the temperature dial in terms of choosing the kind of fabrics that
you want to iron.
Note: If you want to use the steam ironing, we suggest you to adjust the
temperature dial on MAX.
When the iron operating light indicator goes out the device will be ready
for use.
Note: During the whole operating time, the iron operating light indicator
will go on and off in erratic intervals, this is normal.
g) Adjust the steam jet by turning the steam temperature dial.
To make the steam jet come out, press the steam
If the steam stops coming out, this is probably because there is no more
water in the tank. In order to continue ironing, follow the instructions of the
paragraph "SUPPLYING WATER WHILE OPERATING"。
h) ECO mode:
If need lower steam rate, long press the power switch for 2 seconds,
release the power switch to start ECO mode (This mode is based on
energy efficiency, the steam rate is lower). For ECO mode, all the
function is exactly the same as the normal mode, except the steam rate is
smaller, If the user need to exit to the normal mode, long press the power
switch for 2 seconds and release the power switch; If need to turn off the
iron, please press the power switch.
i) Cleaning system:
Self-clean Mode (When cleaning, the steam hole of the soleplate will
discharge a lot of sewage, please be prepared well in advance), and the
iron has intelligent reminder for cleaning mode and active cleaning mode
respectively. The intelligent reminder for cleaning mode means after
accumulates to 36 hours using, the power indicator will blink and beep for
three times to remind the user to clean the iron, then long press the
power switch for 6 seconds until the power indicator blink and beep for 3
times again, this is just the time for pressing the trigger, the iron will enter
into cleaning mode and begin to discharge the sewage from the steam
hole of the soleplate; It will automatically exit the cleaning model after
cleaning for 1 minute,and the power indicator will stop blinking and beep
for 3 times. If the user need to exit the cleaning mode at any time, please
press 6 second until the power indicator stop blinking and beep for three
times, then cleaning mode is finished.
j) Steam boost:
In normal using the iron, press the steam button continuously by 2 times
in 1 second, and the iron will release a large number of steam to form the
steam explosion in 2 second.
k) The soleplate of iron can only be placed on the insulation silicone pad
(three soft silicone) of the station and can touch with lock, and cannot
touch any other plastic part, otherwise will burn the plastic parts.
l) When the steam iron is used for the first time after being placed for a long
time, some slight powders will spray out from the soleplate, please do not
spray toward the clothes directly for the first 5 seconds when in every
using.
.
trigger