VOX electronics VF2510F Manual De Usuario página 22

Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. Only a
qualified electrician or a competent person must do the troubleshooting that is
not in this manual.
Important! There are some sounds during normal use (compressor, refrigerant circulation).
Problem
Appliance does not work
Appliance freezes too
much
The food is not frozen
enough.
Heavy build-up of
frost on the door seaI.
Unusual noises
If the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. Write the necessary data here, refer to the
rating plate.
Possible cause
Mains plug is not plugged in or
is Ioose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold or
the appliance runs at MAX
setting.
Temperature is not properly
adjusted.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
Door seal is not air-tight.
Appliance is not Ievel.
The appliance is touching the waII
or other objects.
A component, e.g. a pipe, on
the rea r of the appliance is
touching another part of the
appliance or the wall.
19
Solution
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
Please look in the initial Temperature
Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation to a
colder setting temporarily.
Please look in the installation location
section.
Carefully warm the leaking sections of
the door seal with a hair dryer (on a cool
setting). At the same time shape the
warmed door seal by hand such that it
sits correctly.
Re-adjust the feet.
Move the appliance slightly.
If necessary, carefully bend the
component out of the way.