CoolStar WMT12000 Manual Operativo página 24

6.10.3 Add Home Appliances:
1）Choose the wired controller model, then go to add the device.
2）Operate the wired controller according to APP prompts.
①点击线控器上的"菜单"键，选择"网络设定"，
点击"确认"
②选择"AP模式"，点击"确认"
③点击线控器"右键"，然后点击"确认"，进入
WLAN
AP模式，"WiFi图标"闪烁
3）Wait for the home appliance to connect, and click "Finish".
4) After the appliance is successfully connected, the LCD icon"
of the wired controller is constantly on, and the air conditioner
can be controlled through the APP.
5) If the network distribution process fails, or the mobile connection
demands reconnection and replacement, operate "WLAN Factory
Reset" on the wired controller, and then repeat the above process.
Warning and troubleshooting
for networking failures
When the product is connected to the network, please make
sure that the phone is as close as possible to the product.
We only support 2.4GHz band routers at present.
Special characters (punctuation, spaces, etc.) are not
recommended as part of the WLAN name.
It is recommended that you connect no more than 10 devices
to a single router lest home appliances are affected by weak
or unstable network signal.
If the password of the router or WLAN is changed, clear all
settings and reset the appliance.
The contents of APP might change in version updates and
actual operation shall prevail.
22
"