Restoring Factory Settings; Messages - Esoteric D-02X Manual Del Usuario

Troubleshooting (continued)

Restoring factory settings

Settings are retained even if the power plug is disconnected .
Follow these procedures to restore all settings to their factory
defaults and clear the unit's memory .
1
Turn the unit off.
If the power is on, press the POWER button and wait at least
30 seconds before proceeding .
2
Press the POWER button while pressing and holding
the MENU button.
When "Setup CLR" (clear settings) appears on the display, release
the MENU button .
20

Messages

"– – –" appears in the sampling frequency display area.
There is a problem with the input signal .
Do not input signals other than PCM or DSD .
Check the connection with the digital device .
This unit cannot decode signals in formats such as Dolby Digital,
DTS and AAC . Have the playback device convert the signal to PCM
before output .
No sampling frequency is shown to the right of "INPUT" on the
display.
The digital signal cannot be locked . Press the INPUT button to
select a connector that has a digital source device connected .
Turn the connected device on . Check the settings of the con-
nected device .
CLOCK!
Check settings related to the clock .
If there is no input clock, "– – –" will appear in the clock frequency
display area .
If the set mode and the input clock are incorrect, the clock fre-
quency display area will blink .