Intended Use - DeWalt DCA120 Manual De Instrucciones

FIG. 1
B
A

INTENDED USE

This corded power supply is designed for professional use in D
120V Max* FLEXVOLT™ tools.
DO NOT use under wet conditions or in presence of flammable liquids
or gases.
DO NOT let children come into contact with the tool. Supervision is
required when inexperienced operators use this tool.
INTRODUCTION
The DCA120 D WALT corded power supply is designed to provide
e
power for D WALT 120V Max* FLEXVOLT™ cordless tools.
e
Your D WALT corded power supply should only be used with standard
e
household 120 VAC, 50/60 Hz power and not with DC power sources.
The DCA120 corded power supply is suitable for use with both
grounded and double insulated 120V Max* FLEXVOLT™ cordless
tools. When the power supply is utilized with a grounded tool, the tool
inlet will be equipped with a ground prong that allows the ground path
from the tool to connect to the power supply. When the power supply
is utilized in a double insulated tool, the tool inlet will not contain a
ground prong and no ground connection will be made from the tool to
the power supply as double insulated tools are not required to have a
ground connection.
Additional Specific Usage Instructions
The corded power supply may become warm to the touch during use.
This is a normal condition and does not indicate a problem.
C
IMPORTANT. The power supply is not user serviceable. There are no
user serviceable parts inside the power supply.
Installing and Removing the Corded Power
Supply into and from Tool (Fig. 2–4)
Before inserting the corded power supply into your tool, remove the
end of the dust cover (D, Fig. 2) from the tool's corded power supply
receptacle if applicable. Pull the dust cover away from the tool's
WALT
e
corded power supply receptacle so that it does not interfere with
insertion of the corded power supply. Inspect the tool's corded power
supply receptacle for debris. Debris inside the receptacle can prevent
the corded power supply from fully seating. If debris is present, clean
it using low pressure air. Refer to tool manual.
WARNING: To minimize the risk of eye injury, always wear ANSI
Z87.1 approved eye protection and respiratory protection when
performing this.
NOTICE: The corded power supply is for AC power sources
only when used with a tool. Use with DC power sources could
result in damage to the tool.
To install the corded power supply into your tool:
1. With the corded power supply unplugged, align its AC connector
(A) with the tool's corded power supply receptacle (E, Fig. 2) then
snap into place.
3