Global Mode - Korg SQ-64 Manual Del Usuario

SQ-64 Owner's Manual

Global mode

Press the GLOBAL button to enter global mode.
You can change the pages by pressing the GLOBAL button repeatedly or 64 pads directly. Select the page containing a value that you
want to change, and adjust to a desired value using the PARAM1 - PARAM4 knob.
■ When no tracks are selected
Pad position Global parameter name
A-5 CLOCK SOURCE
A-6 SYNC IN MODE
A-7 SYNC OUT MODE
A-9 MIDI RX PROG. CHANGE
A-10 MIDI TX PROG. CHANGE
A-12 MOD DISPLAY
A-13 KEYBOARD LAYOUT
KEYBOARD BEHAVIOR
A-14 DISPLAY BRIGHTNESS
A-15 AUTO-POWER OFF
B-9 MIDI RX TRANSPORT
B-10 MIDI TX TRANSPORT
PARAM knob Value (initial value is in boldface)
AUTO, INTERNAL, USB, MIDI
PARAM1
4PPQN, 12PPQN, 24PPQN, 48PPQN
PARAM1
ACTIVE HIGH, ACTIVE LOW
PARAM2
PARAM1 2PPQN, 4PPQN, 12PPQN, 24PPQN, 48PPQN Set the sync pulse rate.
PARAM2 ACTIVE HIGH, ACTIVE LOW
PARAM3 TRANSPORT OFF, TRANSPORT ON
PARAM1 ANY, CH1 - CH16
USB OFF, USB ON
PARAM2
MIDI OFF, MIDI ON
PARAM3
CH1 - CH16
PARAM1
PARAM2 USB OFF, USB ON
PARAM3 MIDI1 OFF, MIDI1 ON
PARAM4 MIDI2 OFF, MIDI2 ON
PARAM1 GATES, VALUES
PARAM1 KEYS, ISO, OCTAVE
PARAM2 TRANSPOSE, OVERRIDE
PARAM1 1..5..10
DISABLE, ENABLE
PARAM1
USB OFF, USB ON
PARAM2
MIDI OFF, MIDI ON
PARAM3
PARAM2 USB OFF, USB ON
Parameter details, remarks
Set master sequencer clock source.
Set the sync pulse rate.
Set the sync pulse polarity.
Set the sync pulse polarity.
The right channel of the sync connector will be set high when the sequencer is running and
low when stopped.
Set channel on which MIDI program change messages will be received.
Enable/disable reception of MIDI program change messages from USB-MIDI.
Enable/disable reception of MIDI program change messages from MIDI input.
Set channel on which MIDI program change messages will be transmitted.
Enable/disable transmission of MIDI program change messages to USB-MIDI.
Enable/disable transmission of MIDI program change messages to MIDI1 output.
Enable/disable transmission of MIDI program change messages to MIDI2 output.
Set which data should be displayed on steps.
Set keyboard layout for keyboard mode.
Set the behavior for keyboard mode.
Sets the display brightness level.
Enable/disable auto power off feature.
Enable/disable reception of MIDI transport messages via USB-MIDI.
Enable/disable reception of MIDI transport messages via Legacy MIDI.
Enable/disable transmission of MIDI transport messages to USB-MIDI.
19