Care And Cleaning - Sunbeam OSTER Manual De Instrucciones

it will pour. Its viscosity changes because of changes to the oil' s molecular
structure. When smoke appears on the oils' surface before the temperature
reaches 375° F, your oil will no longer deep-fry effectively.
• When frying fish or chicken, use the oil only once.
• Also, use the oil only once when frying fresh or frozen chicken. A great deal
of moisture is released when frying the chicken, this breaks down the oil
easily and can cause the oil to foam and lower the smoke point.
• Filtering the oil with a cooking oil filter or fine-mesh strainer can help keep
it fresher. Although storing oil in a refrigerator may extend the life of the oil,
this should never be done. The process of chilling oil then bringing the oil to
room temperature causes excessive splattering during the heat up process.
• Store the covered oil in a cool dark place, for up to three months. Also check
the oil before using for color, smell or excessive foaming. Discard the oil if it
shows any of these qualities.
Resetting the overheat protection button
Hinged Lid with
Resetting the Overheat Protection Reset Button may be necessary if unit will not
Window
turn on at start up or if unit appears to have stopped working during use.
1. Unplug the unit from the wall electrical outlet.
2. Allow the unit to cool down.
er Housing
3. Remove any oil from inside the fryer
4. Using a narrow slotted screwdriver or pen,
gently press the recessed reset button on
the bottom of the unit, located near the
center by the arrow. (see Figure 2)
ower Indicator
Adjustable Thermostat
8
CKSTDF102-SS_16ESM1.indd 9-10
Basket Hand
Fryer Basket
Bottom View
Power Cord
Reset Button
Figure
2
www.oster.com

CARE AND CLEANING

WARNING: ALWAYS TURN CONTROL TO "OFF" THEN DISCONNECT PLUG
FROM WALL OUTLET BEFORE DISCONNECTING MAGNETIC CORD.
CAUTION:
• Do not immerse cord sets or fryer in water or any liquid.
• Do not attempt to defeat the detachable magnetic cord system by trying
to permanently attach cord set to product.
• Do not stick pins or other sharp objects in holes on magnetic cord set.
• Do not use any type of steel wool to clean magnetic contacts.
1. Turn unit OFF.
2. Unplug from outlet and allow unit to cool completely.
3. Remove magnetic cord from the fryer socket.
4. When unit has cooled, empty cooking oil. If you plan to reuse the oil, store
fryer with lid closed. (See TIPS FOR OIL USE AND STORAGE on page 7.)
5. When changing the oil, take the opportunity to clean the inside of the
fryer. Open the LID, pour out oil and discard properly; wipe the inside with
paper towels to absorb excess grease. Wash interior of fryer and fry basket
with hot soapy water. Rinse and dry thoroughly. Do not use scouring
pads or abrasive kitchen cleaners.
www.oster.com
9
5/16/16 9:14 AM