Publicidad
Idiomas disponibles
Idiomas disponibles
1. ASSEMBLE PIPES FOR BOTTOM POCKET OF DOOR.
A. Measure width of door between the zippers to determine size.
B. Slide pipes into one another to assemble. NOTE: For added weight, fill pipe with sand and insert plugs.
C. Slide pipe into pocket at bottom of door.
Door Panel Exterior
Width
Between
Zippers
2. ATTACH BUTTERFLY CLEAT TO INSIDE OF SHELTER FRAME
Attach butterfly cleat with screws to second vertical rib, about 8 inches down from cross rail on either side.
Butterfly Cleat
3. ATTACH ROPE ENDS TO OUTSIDE OF SHELTER COVER
A. Cut a small slit/hole, approximately 18 inches in from zipper, on the outside of the cover, just
above the webbing rope. Do this on both sides.
B. Tie a knot around the cover webbing through the hole in the cover.
Shelter Cover Exterior
Cover
Door Panel
Shelter Width
6 ft.
8 ft.
10 ft.
12 ft.
14 ft.
Tie Knot
Rope
Door Width
4 ft.
1 Swedged Poles + 1 Plain Pole
6 ft.
2 Swedged Poles + 1 Plain Pole
8 ft.
3 Swedged Poles + 1 Plain Pole
10 ft.
4 Swedged Poles + 1 Plain Pole
12 ft.
5 Swedged Poles + 1 Plain Pole
Approximately
18"
Page 2
Number of Poles
05_10077-00800_E2
Publicidad
