Before Using For The First Time; Operating Instructions - Throwback PROFESSIONAL ICE SHAVER Manual De Instrucciones

Before Using for the First Time

1. Carefully unpack the Professional Ice Shaver and remove all packaging materials.
WARNING! To reduce the risk of severe injury, keep hands out of the ice chamber. Never place
fingers or other utensils into feed or discharge areas.
2. Turn the clear snow guide clockwise to remove. Wash plastic cones, removable drip tray,
removable snow guide in warm, soapy water; rinse and dry thoroughly.
3. Attach the snow guide to the spout by it rotating counter-clockwise. Replace clean drip tray
under the snow guide.
4. Wipe the exterior of the Professional Ice Shaver with a clean, damp, non-abrasive cloth or
sponge and dry thoroughly.
5. Placerthe Professional Ice Shave on a clean, flat surface near an electrical outlet.
6. The Professional Ice Shaver is now ready for use.

Operating Instructions

1. Check to make sure the snow guide is securely attached to the spout. Turn the snow guide
counter-clockwise to tighten. Replace clean drip tray under the snow guide.
2. Gather your plastic or paper snow cones, ice cubes, syrups and drink mixes, snow cone stand,
straws, snow cone scoop glasses or a serving pitcher for frozen drinks.
3. Turn the lid lock clockwise to unlock. Open the lid. Add the desired amount of ice into the ice
chamber. Close the lid. Turn the lid lock knob counter-clockwise to lock.
NOTE: The ice chamber has a capacity of approximately 32 large ice cubes (1.85''X1.22''X1.02")
or 3-1/2 cups of smaller cubes. This will produce enough ice for 5 snow cones or shaved ice
drinks.
4. For best performance, smaller size ice cubes will feed more smoothly into the ice chamber.
Larger cubes of ice may shave less consistently or will generate more noise and vibration.
Larger chunks of ice must be broken into individual cubes before putting them in the ice
chamber. Always make sure to leave a 1 inch clearance between the lid and the ice cubes.
WARNING: To prevent damage to the Professional Ice Shaver, never turn the Professional Ice
Shaver ON when the ice chamber is empty.
CAUTION: Do not overfill the machine or exceed the maximum ice capacity. The lid should fit
and lock easily onto the ice chamber.
WARNING: The machine is only intended to shave ice only. Never place any other ingredients
into the ice chamber as damage will occur.
CAUTION: Never operate the Professional Ice Shaver without first locking the clear lid. Turn the
lid lock knob clockwise to lock.
5. Plug unit into a 120 V AC 3-prong electrical outlet.
Preparing Snow Cones / Frozen Drinks
Hold a clean plastic cone or drink glass directly under the clear snow guide.
1. Press the ON button on the side of the unit. The button will glow red, 4 LED lights in the front
of the Professional Ice Shaver will illuminate and fine, light and fluffy snow will begin to fall into
the cone.
2. When enough snow has filled the cone or glass, release the ON button. Holding the cone or
glass over the drip tray, cup the top of the snow cone or frozen drink with the shaper.
3. Add your favorite syrup(s), fresh fruit juices, flavorings to the top of the cones/drinks and enjoy.
For fun rainbow treats, collect shaved ice on the bottom of the cones or drinks. Add the first
flavor syrup or juice. Shave the next layer of ice over the first. Add another flavor or juice. The
possibilities are endless!
4. The snow cone stand is helpful when preparing multiple cones. Place cones securely in each
holder to serve.
SO-314228_60048_Throwback_Hawaiian ice shaver_W&S_IM_R6.indd 6
6
2017-06-02 2:26 PM