User Maintenance Instructions; Care & Cleaning Instructions; Storing Instructions - Throwback PROFESSIONAL ICE SHAVER Manual De Instrucciones

USER MAINTENANCE INSTRUCTIONS

This appliance requires little maintenance. It contains no user-serviceable parts. Any servicing
requiring disassembly other than cleaning must be performed by a qualified appliance repair
technician.
Care & Cleaning Instructions
1. Unplug the Professional Ice Shaver before cleaning.
2. Never immerse the main housing in water or other liquid.
3. Unlock the lid and open. Check to make sure there is no ice remaining in the ice storage
container.
4. ICE BLOCKAGES: If ice gets blocked in the ice chamber, do not try and dislodge; do not force
the motor to operate and do not place fingers or utensils into the ice chamber or snow guide.
5. Allow 5 minutes for the ice to start melting and try turning on the machine again to see if the
ice will dislodge itself. If still stuck wait another 5-10 minutes and try running the motor again.
6. Since only ice made from water should be used in the unit, minimal cleaning should be
required. When done using the Professional Ice Shaver, wipe dry with a soft cloth the clear
lid, removable snow guide, the ice chamber (do not try drying close to the blades), etc. Always
leave the lid open for a few hours after use so, the inside of the unit can completely dry out.
Never close the lid and put the unit away when it is still wet. If any syrups, juice, etc. gets on
any the parts of the unit, use warm soapy water with mild detergent on a soft cloth to clean,
and then wipe dry.
WARNING: To avoid injuries, never insert your fingers, cleaning rags or towels into the ice
chamber.
7. Hand wash plastic cones, cone stand, drip tray, snow shaper and snow guide in warm, soapy
water. Rinse and dry thoroughly.
8. For your convenience, the plastic cones, snow shaper and snow guide are top-rack dishwasher safe.
9. Wipe the housing and non-slip feet with a clean and soft dry cloth.
10. Do not scour surfaces with steel wool or use abrasive cleaners.
WARNING: The ice shaving blade is very sharp. Never attempt to sharpen the blade as injury
may occur and the warranty will be invalidated.

Storing Instructions

1. Unplug unit.
2. Store the Professional Ice Shaver fully assembled with lid locked on top of the ice chamber in
its original box.
3. Store in a clean, dry place.
4. Do not wrap the cord or put any stress on cord where it enters unit, as this could cause cord to
fray and break.
SO-314228_60048_Throwback_Hawaiian ice shaver_W&S_IM_R6.indd 7
7
2017-06-02 2:26 PM