Melchioni Zodiac VC-7INC Manual Del Usuario página 10

1. The A, G, B, V connection terminals of the indoor monitor connect to the 1, 2, 3, 4
connection terminals of the outdoor camera.
2. The 5,6 connection terminals of the outdoor camera connect to the electronic lock.
3. The "﹢", "﹣ " connection terminal of the indoor monitor connect to the DC15V power.
7. Operation Instruction
1. Press CALL button of outdoor camera and graceful rings will be heard from indoor
monitor and images of visitors will be seen. Then you can talk with them and see them just
by pressing TALK button of the indoor monitor. The talking time can last about 120
seconds. Touch TALK button to end a conversation at any time.
2. Press UNLOCK button to release the door.
3. Touching MONITOR button can monitor the outside. The monitoring time lasts about 40
seconds.
4. Touching TALK button after pressing MONITOR button can monitor the talking is over.
5. The brightness, and chroma can be adjusted by using the button or knob to reach the
best result.
6. Talking volume adjustable by using knob.
7. 16 polyphonic melodies for option by using the button at the side of monitor.
8. Ring volume adjustable by switch.
9. Inner-calling between monitors:
(1) Press the interphone button briefly on a monitor to call another monitors.
(2) Press the talk button on a called monitor to commence communication with the calling
monitor.
(3) Press the talk button against to end communication and return to standby mode.
Baby-monitoring:
(1) Press the interphone button from the monitor in Baby's room.
(2) Press and hold the talk button 4 seconds on the other called monitor until a BEEP
sound, When baby monitoring is activated between monitors, the power and baby
monitoring LED(blue) on the monitors will blink and the other monitors will be able to hear
audio from the baby's room.
10. Broadcasting function:
(1) Press and hod the interphone button on the monitor 4 seconds until BEEP sound then
intercommunication is established without the
called monitors'required to answer.
(2) Press the talk button to return to standby mode from any monitor.
11. Melody mute set-up: Press and hold the Unlock button on the monitor for 4 seconds in
standby mode until a BEEP is heard. The "Melody mute" LED (red) will remain on. In this
mode, there will be no door call sound heard from this indoor monitor when the call button
is pressed by the callers, to un-mute melody, repeat the process above.
12. Melody setup
Press and hold the monitor button 4 seconds until beep is heard to select a different 16
tones and tones can be selected by pressing the monitor button sequentially.
Melody volume setup
Press and hold the monitor button 4 seconds until beep is heard.
A preferred volume level can be selected by pressing the talk button.