Halfen HUC Serie Instrucciones De Montaje página 3

HALFEN HUC
Identifi cation
Stud heads
Factory mark
HSC
Product name
Bar diameter
20
d = 12 - 14 - 16 - 20 - 25
S
mm
Sleeves
Product name
HSC-B
20/M20
Bar diam./ Thread
xyy-z
Factory mark
Standard design
Product name
HSC-B
20/M20
Bar diam./ Thread
A 4
xyy-z
Material design
Factory mark
Design with A4 stainless steel
Female bars
Colour of
Bar diam.
Thread thread pro-
d
s
tection cap
12 M 12 x 1.75* green
14 M 14 x 2.0* red
16 M 16 x 2.0* orange
20 M 20 x 2.5* bright blue
25 M 27 x 3.0* yellow
* Metric ISO internal thread and tole-
rance grade 6H acc. to (DIN 13-1)
© 2018 HALFEN · INST_HUC 09/18 · www.halfen.com
Assembling example
HALFEN HSC-B Concrete steel con-
nection with 2x4 HSC-B SH single
headed female bars fi tted to a steel
beam or a steel corbel to a rein-
forced concrete column
1. Check the hole layout of the position-
ing and front plate before installing.
2. Replace the thread
protection cap.
3. Assembly of the connection –
HSC-B SH single headed female
bars are fi xed with fl at headed
screws to the positioning plate.
Layout and position are according
to the engineer's specifi cation.
4. Stud heads can be aligned horizon-
tally or vertically. The engineer's
specifi cations have to be observed.
Vertical anchor-head placement
Assembly Instructions
Horizontal anchor-head placement
5. Cut and fi t self adhesive sealin
tape to form a recess in the con-
crete at the connection location.
When used with steel formwork a
magnet is placed in the middle of
the positioning plate.
This type of assembly requires no
formwork penetration. The positio-
ning plate is not fl ush with the form-
work.
Bolts:
- metric ISO external thread
and tolerance grade 6h
acc. to DIN 13-1
- hot-dip galvanized bolts with
marking "U" after steel grade
marking eg. "8.8 U"
3