Makita HR2800 Manual De Instrucciones página 7

Bit grease
Coat the bit shank head beforehand with a small
amount of bit grease (about 0.5 - 1 g).
This chuck lubrication assures smooth action and lon-
ger service life.
Installing or removing the bit
2
1
► 1. Bit shank 2. Bit grease
Clean the bit shank and apply bit grease before install-
ing the bit.
1
2
► 1. Bit 2. Chuck cover
Insert the bit into the tool. Turn the bit and push it in until
it engages.
After installing, always make sure that the bit is securely
held in place by trying to pull it out.
To remove the bit, pull the chuck cover down all the way
and pull the bit out.
1
2
► 1. Bit 2. Chuck cover
Bit angle (when chipping, scaling or
demolishing)
For models HR2810, HR2810T,
HR2811F, HR2811FT
► 1. Action mode changing knob
The bit can be secured at the desired angle. To change
the bit angle, rotate the action mode changing knob to
the O symbol. Turn the bit to the desired angle.
Rotate the action mode changing knob to the
Then make sure that the bit is securely held in place by
turning it slightly.
► 1. Action mode changing knob
Depth gauge
1
► 1. Depth gauge
7 ENGLISH
1
symbol.
1