Working Instructions - Ega Master 60005 Manual De Instrucciones

Check that all components are fine and correctly in place.
1. Fill the tank with clean water. The filter must be always correctly placed.
2. Connect the hose to the installation to be checked.
3. Connnect the hose to the pump, getting sure that there is no leakage.
4. Close up the valve.
5. Pump up until reach the pressure test.
6. Leave the pump with required pressure during testing time.
7. Open up the valve allowing water ways.
1
5
OF PRESSURE OR IMPROPERLY PUMPING OF THE TESTING PUMPS
When the testing pump shows an effect of loss of pressure or improperly pumping, because it
is hard or it does not pump water, the main reason used to be that the outlet valve is blocked by
impurities of water as lime, cement, dust or other sustances.

WORKING INSTRUCTIONS

2
6
SOLUTION TO THE POSSIBLE PROBLEM OF LOSS
3
7
4
7