Safety Instructions - Boost CM003LED Manual De Instrucciones

Safety Instructions

•
Please keep this User Manual for future reference. If you sell the unit to another user, be sure that he also receives
this instruction booklet.
•
Unpack and check the unit carefully that it has not been damaged during transport before using the unit.
•
Before operating, ensure that the voltage and frequency of power supply match the power requirements of the unit.
•
It's important to ground the yellow/green conductor to earth in order to avoid electric shock.
•
The unit is for indoor use only in a dry location.
•
The unit must be installed in a location with adequate ventilation, at least 30cm from adjacent surfaces. Be sure that
no ventilation slots are blocked.
•
Disconnect mains power before fuse replacement or servicing.
•
Replace fuse only with the same type.
• Make sure there are no inflammable materials close to the unit during operation.
• Use safety cable when fixing this unit.
• In the event of serious operating problem, stop using the unit immediately.
• Never try to repair the unit by yourself. Repair carried out by unskilled people can lead to damage or malfunction.
Please contact the nearest authorized technical assistance center and always use the same type of spare parts.
• Do not touch any wires during operation as high voltage might be causing electric shock.
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain
readily operable.
2. Specifications
Supply Voltage: ............................................................................................. AC220～240V 50/60HZ
Power: ........................................................................................................................................ 20W
Light source: .................. 5mm 56 LEDs, red=16, green=12, blue=8, white=12 and Amber=8
Fuse: .............................................................................................................................................. 1A
Operating modes： ..................................................................................... Auto-run, Sound Control
Dimensions: ....................................................................................................... 302 x 152 x 168mm
Weight: ................................................................................................................................... 1.45kg
3. Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to avoid
vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit is secure and
able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can hold 12 times the weight
of the unit when installing the fixture.
The equipment must be fixed by professionals at a place where is out of the reach of people and where nobody can pass
by or under it.
4. Operation
The unit can work either automatically or follow the rhythm of the music via the built-in microphone on the rear panel.
Plug the unit into an appropriate mains outlet that supplies the required voltage for the unit and it will start working.
©Copyright LOTRONIC 2013
GB
LED COLOR MOON 2