Setting Mode; Meanings Of Items Shown In Setting Mode - Esoteric D-05X Manual Del Usuario

Setting mode

1
Press the MENU button repeatedly to select the
desired setting item.
Each time you press the MENU button, the item shown on the
display changes .
UPCONV>
c
DSD_F>
c
CLK>
c
CLKOUT>
The UPCONV, DSD_F, CLK, CLKOUT and CLK_TH settings can be
set independently for each input . Select the input source to be
set before making these settings .
Press the INPUT button or do nothing for 10 seconds to exit set-
ting mode and return to the ordinary display .
2
Press the SELECT button repeatedly to change
the setting.
For information about the settings, see pages 14–16 .
Setting mode will end and the ordinary display will reappear if
nothing is done for 10 seconds or the INPUT button is pressed
once .
o Settings are retained even if the power plug is disconnected .
APS>
3
DPaOFF>
3
DIMMER>
3
CLK_TH>

Meanings of items shown in setting mode

UPCONV>***
This is the upconversion setting .
This changes the sampling frequency used for upconversion
(page 14) .
DSD_F>***
This turns the DSD filter on and off (page 14) .
CLK>***
This is the clock sync mode setting .
Use this to set the clock sync mode to use with external clock syn-
chronization and clock output to devices that support clock sync,
for example (page 15) .
CLKOUT>***
This is the clock output frequency setting .
This sets the internal clock frequency output from the CLOCK
SYNC OUT connector when set to CLK>OUT . (This only appears
when set to CLK>OUT (page 15) . )
CLK_TH>***
This is the clock output setting .
When external clock is being input, the input clock can be output
as is (through) . (This only appears when set to CLK>IN, MCK IN or
MCK10M (page 16) . )
DIMMER>***
This sets the dimmer .
You can set the brightness of this unit's display and indicators to
one of four levels (page 16) .
DPaOFF>***
This sets automatic display darkening (page 16) .
APS>***
This sets automatic power saving (page 16) .
13