Conexiones Fijas; Jack Outputs; Combi-Con Connectors - BSS FCS 966 Manual De Usuario

Conexiones de Audio
Control operations Control operations
Control operations Control operations Control operations
5.4 Salidas Jack
Fig 5.7
Fig 5.8

5.5 Conexiones fijas

Combi-con
Fig 5.9
Fig 5.10
1 2
The Jack outputs are electrically identical to the XLR outputs. The signal 'HOT,
+, or in phase' signal is connected to the jack plug tip. The 'COLD, -, or out of
phase' signal is connected to the ring with the shield being connected directly
to the chassis.
E A C
Connection to unbalanced inputs may be done by connecting the tip to the
signal input, and the ring to the input shield. The FCS 966 shield may or may
not be connected to the equipment shield at the equipment end.
E A C
Each channel of the FCS 966 is fitted with a six way pluggable terminal block
or 'Combi-Con' connector. This connector carries both the balanced input and
balanced output signals for that channel.
The signals are electrically identical to those on the XLR connectors. For
convenience it may be desired to use individual 3 way plugs for independent
connection of input and output signals wired as follows:
ColdNegativo '-'
Positivo '+'
Malla
Conector Combi-con
C
E
A
Salida jack del 966
Carcasa: Masa
Extremo: Positivo '+'
Anillo: Negativo '-'
C
E
A
Union
Salida jack del 966 Entrada jack no balanceada
Masa + - Masa +
Combi-Con connector
(panel posterior)
Salida balanceada Conector Combi-con del 966
Masa
Positivo '+'
Negativo '-'
Entrada balanceada
Masa
Positivo '+'
Negativo '-'
www.audiovias.com
Negativo '-'
Positivo '+'
Carcasa
Entrada balanceada
Masa
Positivo '+'
Negativo '-'
Positivo (Senal)
Malla
-
Negativo '-'
Positivo '+'
Malla