ABAC 2809913206 Instrucciones De Uso página 15

EN
CAUTION:
• Since this manual refers to international standards, we recommend to previously obtain information on local
safety regulations and to make sure they are observed.
• Compressed air is a potentially powerful power source, therefore use extreme caution when using the
compressor or the accessory kit.
• Using compressed air requires knowing and observing any applicable regulation.
• Do not allow unattended use by non – experienced staff. Keep children and animals out of the work area.
• Assume a stable position to properly make use of the tool and grip it firmly.
• Accidental and unexpected tool movement may represent a serious hazard.
• Do not employ the tools in premises that have a potentially explosive atmosphere, or where there are dust
deposits, gas pipelines or electric duct-lines.
• Operate the tool in a suitably ventilated environment only.
• Pay special attention for processed materials that are highly flammable or to their potential explosion.
• Bear in mind that the poor consistency of the machined piece, or the poor quality of the accessories in use, may
cause the dangerous flinging of chips or fragments.
• Be careful for possible sparks and machining slag.
• Tools with rotary parts and their accessories may get entangled and twist rubberised or metal-reinforced gloves.
As such, be especially careful when using them.
• Pneumatic hammers are not suitable for the demolition of reinforced concrete.
GENERAL SAFETY REGULATIONS
• Do not use the equipment without the required safety devices.
• Never hold the tool from the compressed air hose when carrying it.
• Do not let other people approach the work area.
• Do not aim the air jet or the tool in your direction or towards any other third party.
• By all means, avoid direct contact with the tool engaged immediately after having used it, as its surface may be
very hot.
• Do not touch the equipment moving parts during its operation.
• Do not open nor modify in any way the tool or its accessories. Any repair should be carried out only by trained
staff.
• If working with metal, remember to direct the cutting so that it does not constitute a hazard, for the operator
or other by-standers.
• Read and understand the contents of this manual before installing, operating, repairing, maintaining, changing
accessories this tool.
• Only qualified and trained operators should install, adjust or use the tool.
• Connect compressed air only when the equipment is shut down.
• For tool optimum performance, make sure hose and connection size are those required.
• Before starting up the tool, check its connection and make sure the compressed air hose is not damaged.
WHAT YOU SHOULD DO
15