Switching On/Off; Maintenance And Storage - EDM KOMA tools Manual De Instrucciones

SWITCHING ON/OFF

Switching on: [F6]
Press the switch (4)
Switching off: [F6]:
Wring out the switch (4)
SMOOTH REGULATION OF SPEED
The tool works with variable speed from 0 to maximum
depending on pressure put upon the button of the switch "it
is switched on/is switched off" (4). Speed of the tool increases
in case of pressure increment by the switch "it is switched
on/is switched off" (4). Easy clicking results in low rotational
speed, providing the smooth start.
Do not load the machine so heavily that it comes to a
standstill.
CHANGE OF THE DIRECTION
OF ROTATION
Regulate a rotation sense by means of the switch of a rotation
sense (3) only after a complete stop of the tool.
The rotation sense of the tool can be switched by means of
the switch of a rotation sense (3) (when the switch "it is
switched on/is switched off" (4) is wrung out, the switch of a
rotation sense (3) is disabled). [F7]
Rotation clockwise
To turn the switch of a rotation sense (3) to the right to a stop
(for drilling, fixing of screws, etc.).
Rotation counterclockwise
To turn the switch of a rotation sense (3) to the left to a stop
(for loosening and removal of screws and nuts).
EN INSTRUCTION MANUAL
CORDLESS DRILL 14.4V
BACKLIGHT
Illumination is located on the screw gun handle case. When
pressing the switch illumination automatically lights up.

MAINTENANCE AND STORAGE

CAUTION. Make sure that the machine is not live when
carrying out maintenance work on the motor.
Always keep the tool and the ventilation slots (if present)
cleaned. Regular cleaning and maintenance of the appliance
will ensure efficiency and prolong the life of your tool.
If the tool should fail despite the rigorous manufacturing and
testing procedures, the repair should be carried out by an
authorized Total Tools customer service.
Keep all nuts, bolts, and screws tight, to be sure the tool is in
safe working condition.
Replace worn or damaged parts for safety.
Use only original spare parts. Parts not produced by
manufacturer may cause poor fit and possible injury.
Store the tool in a dry room out of reach of kids and away
from any flammable material.
Never wet the device or spray water on it!
RECYCLING
Tool, accessories and packaging should be sorted for
environment-friendly recycling.
The plastic components are labeled for categorized recycling.
These instructions are
manufactured without chlorine.
REF. 08703
printed on recycled paper