ProKlima ALASKA 120 C+H Manual De Instrucciones página 14

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
Anleitung Alaska 120 C+H_SPK7:Anleitung MKA 7000_D
GB
Check that the actual mains voltage is the same
as the mains voltage specified on the rating
plate.
The equipment may only be operated from a
properly earthed shock-proof socket.
For electrical safety purposes we recommend
that you install a residual current device circuit-
breaker (earth-leakage circuit-breaker).
Important! Do not extend the cable and never
use multiple plugs. Otherwise there is a risk that
electrical safety can no longer be guaranteed.
Never pull the mains plug out of the socket while
the equipment is running.
In the event of any abnormalities in the operation
of the equipment (e.g. smell of burning),
immediately switch off the equipment and pull
the plug. There is a risk of electric shock or fire
damage if the equipment is allowed to continue
running with possible defects.
Never pull the plug out of the socket by pulling
the cable. Hold the mains plug firmly to pull it out
of the socket. Otherwise there is a risk of
damaging the cable.
Never actuate any switches with wet hands.
Otherwise there is a danger of an electric shock.
Never allow the cool air to blow directly at you
and do not allow the air in the room to become
too cold. This may lead to discomfort and may
also be harmful to health.
Never place and plants or animals directly in the
path of the flow of cool air. Plants or animals may
suffer under the effect of the flow of cool air.
Never poke fingers or objects in the air outlet
vents. The rotating fan can cause injuries.
Never attempt to repair the air conditioner
yourself. Improper repair and maintenance work
can result in damage to the equipment and
cause fires or damage from condensation water.
Always switch off the equipment and pull the
plug before you start to clean it (risk of injury).
Never clean the air conditioner with water. This
could result in an electric shock or fire.
Do not use any inflammable agents for cleaning
purposes as they could cause a fire or
deformation.
Never touch any metal parts on the inside of the
equipment when removing the air filter. You may
injure yourself.
If the air conditioner is not used for a lengthy
period of time the room has to be ventilated
every now and then, otherwise there is a risk of
lack of oxygen.
Never install the equipment in a room in which
combustible gases can be emitted. Emitted
gases may collect and cause an explosion.
Never hold any burning objects close to the
14
28.11.2006
8:02 Uhr
equipment if they could be directly affected by
the emitted air. This may result in their not being
completely burnt.
Pull the mains plug out of the socket if the
equipment is not going to be used for some time.
Always switch off the equipment and pull out the
power plug during a storm. Electrical parts may
get damaged as a result of overvoltage.
If the coolant circuit should develop a leak,
switch off the equipment immediately and
contact your service partner.
There is a risk of harmful gas being generated if
any of the coolant escapes and comes into
contact with a flame. Switch off the equipment
immediately.
To avoid electromagnetic interference the device
should be kept away from televisions and radios.
Check that the condensation water can run off
unhindered. Water damage can result if the
condensation water cannot run off properly.
Never remove the blower grille from the outdoor
device. The rotating fan may cause an injury.
Do not let children climb on the outdoor device,
do not place any heavy objects on it, and do not
use any unsteady or rusty wall brackets for the
outdoor device. There is a risk of accident from
the outdoor device falling off the bracket or
toppling over.
4. Layout
Front (Fig. 1)
1. Hot air outlet grille
2. Carry handle
3. Refrigerant connecting tubes
4. Air inlet
5. Control panel
6. Cold air outlet grille
7. Recessed grip
8. Guide rollers
Back of device (Fig. 2)
9. Recessed grip
10. Power cable
11. Cord rewind
12. Air intake filter
13. Connection box for refrigerant connecting line
Accessories (Fig. 3)
14. Activated carbon filter
15. Holder for outdoor device
16. Open-ended wrench kit
17. Remote control
18. Assembly bag (without diagram)
Seite 14

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

23.602.25

Tabla de contenido