Maintenance And Inspection - MAGLOGIX MagnaDrill MXD-1.5 Manual De Instrucciones

Maintenance and Inspection

The user is obliged to maintain and service the core drilling machine in compliance with the specifications in the operation
manual and according to the country-specific standards and regulations.
The maintenance intervals are classified according to the frequency with which the maintenance should be carried out.
Always disconnect the machine from the mains before any maintenance operation, otherwise there
is a risk of injury due to unintentional machine switch-on.
Before every use...

inspect the core drilling machine and underside of the magnet for visible signs of damage

clean the surface of the work piece and the underside of the magnet

check the blocking function of the safety tab on the lever

check the correct, firm fit of the core drill

check connection cables for damage
Weekly...

check that the operating lever and safety tab are working properly

use dry compressed air to blow the motor compartment out from the outside

check the underside of the magnet for scratches, pressure points or cracks. Have the magnet repaired by the
manufacturer if necessary

in particular, consider the motor LED and change the carbon brushes if necessary
Monthly...

check the markings and labelling on the core drilling machine for legibility and damage. Replace them if
necessary

clean all the sliding surfaces regularly, re-lubricate them and set the pre-tension of the slide
Annually...

replace the gear oil or gear grease
Maintenance, testing and repair work may only be carried out by qualified electricians according to the regulations valid in
the respective country.
Only use genuine Maglogix
An overview of spare parts can be found at the end of this operation manual.
®
spare parts.
11