Remote Control Handset; Power Supply - König Electronic HAV-PRCD21 Manual De Uso

16. REMOTE SENSOR
17. USB SLOT COMPATIBLE
18. TUNING CONTROL
19. BAND SELECTOR (AM · FM · FM · ST.)
20. BATTERY DOOR
21. AC MAINS

REMOTE CONTROL HANDSET

The functions of the remote control buttons are the same as those of the of CD/MP3/USB/SD section.
Select the MP3/CD tracks using the (+10) / (-10) button.
- The remote control volume button has no function in the radio mode.
Fast-forward or rewind a song
1. Press and hold next/fast-forward
During fast-forward or rewind function, the output will be muted until release.
2. When you recognize the passage you want, release
- Normal playback resumes.
Selecting the folder
- Press and hold the +10/FOL+button or -10/FOL- button for 3 sec, folder number will show the
sequence "F01->F02....", just release the button when your favourite folder is displayed.
- The display will show the folder number and the song number. Alternately within 5 sec.

POWER SUPPLY

Using AC power
1. Check if the powser voltage, as shown on the type plate located on the bottom of the set,
corresponds to your local AC power supply. If it does not, consult your dealer or service centre.
2. Connect the power cord to the AC MAINS inlet and the wall outlet. The power supply is now
connected and ready for use.
3. To switch off completely, unplug the power cord from the wall outlet.
- Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.
Batteries (not included)
Open the battery compartment and insert eight batteries, type R-14, UM-2 or C-cells, (preferably
alkaline) with the correct polarity as indicated by the "+" and "–" symbols inside the compartment.
Batteries contain chemical substances, so they should be disposed of properly.
Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the
batteries to burst. Therefore:
Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
- When inserting new batteries, do not try to mix old batteries with new ones.
- Remove the batteries if the set will not be used for a long time.
Installing batteries in the remote control
1. Open the battery cover to remove it.
2. Insert two (AAA) batteries (not included) correctly so that the + and – polarities match the polarity
diagrams inside the battery compartment.
Note:
* About half a year of normal operation can be expected when using the general batteries.
* When the batteries are exhausted, the commander should no longer operate the system. Replace
both batteries with new ones.
* When the commander will not be used for a long time, remove the batteries to avoid damage caused
by battery leakage and corrosion.
* Avoid keeping the commander in extremely hot or humid locations.
* There should be no obstacles between the remote control and the remote sensor and they should be
kept within 30° ranges.
* The remote control's operating distance is about 0.2 m to 6 m away from the remote sensor.
To listen to MP3 music files on your USB flash
memory stick
Select AM/FM/FM ST. stations
Select AM/FM/FM ST. wave band
To open battery compartment
Inlet for power cord
or previous/rewind .
or .
3