Basic Function - König Electronic HAV-PRCD21 Manual De Uso

To prevent sound from skipping (Anti-Skip System)
The ESP (electronic shockproof protection) system applies semiconductor memory to prevent aborting
while playing when the machine is subjected to external force.
That means the ESP function is already turned on.
The ESP function CD/MP3 is automatically activated whenever the player is used for playing CD/MP3
discs.
- CD ESP time is about 2 seconds.
- MP3 ESP time is about 5 seconds.
Note:
When using the ANTISHOCK functions, the battery power consumption increases because the disc
rotates faster than normal and the dynamic memory is active.
While the ANTISHOCK function provides continuous sound output when the unit is subjected to shock
or vibration, it will not correct errors arising from the use of defective, scratched or dirty discs.

BASIC FUNCTION

Switching power on/off: Save energy whether you are using mains or battery supply, to avoid
unnecessary energy consumption always put off the source selector.
General operation
1. To select your sound source, adjust the source selector to MP3/CD/OFF/RADIO.
2. Adjust the sound using VOLUME.
3. To switch off the set, adjust the source selector to the off position.
RADIO
Radio reception
1. Slide the FUNCTION selector to RADIO.
2. Slide the BAND selector to the desired setting -FM STEREO, FM, AM.
3. Rotate the TUNING control to find the desired stations.
NOTE: If the BAND selector is set to the FM stereo station, the FM stereo LED indicator will
illuminate.
4. When you have finished listening, slide the FUNCTION selector to the other position to shut the
power off.
- For FM, pull out the telescopic antenna. Incline and turn the antenna. Reduce its length if the
signal is too strong (very close to a transmitter).
- For AM, the set is provided with a built-in antenna so the telescopic antenna needs not be
adjusted.
Earphone output
Plug in a 3.5 mm earphone plug into the earphone output on the front panel of the unit for private use.
The speakers will be automatically disconnected when you use the earphone output.
PROGRAMMING METHOD
(1) Press the [PROGRAM] key at STOP mode, the system will go to PROGRAM mode.
- The PRG icon and P01 will blink at 2 Hz. This prompts the user to enter the first songs in the
program PLAY list.
(2) The user can select the desired tracks by using the [NEXT] [+10 Track], [BACK] [-10 Track] keys.
Once these keys are pressed, the display will show the selected track.
(3) After selecting the desired track, press the [PROGRAM] key again and it will be stored in the
memory. A maximum of 99 tracks can be programmed when steps (2) to (3) are repeated.
(4) If the [STOP] key is pressed during program mode, the selected tracks will be stored in the memory
and will return to STOP mode (continuous play mode)
(5) If the [PLAY] key is pressed during program mode, it will start the program PLAY mode. PLAY starts
from P01 Track.
Erasing a Program
You can erase the contents of the memory: Press the STOP button 2 times.
4