Super Ego 1500000447 Instrucciones De Uso página 12

Operating instructions
1. Preparing the tube
NOTE
The surfaces to be welded must be cleaned
immediately before welding. Protect the surfaces
from weather conditions.
2. Preparing the socket welder
A. Fix the adaptors corresponding to the
diameters of the tubes to be welded to the
heating plate. In no case they may protrude
from the periphery of the heating plate.
B. Connect the
power generator
C. Set the welding temperature: press
, then the up
until the desired temperature is set and
then press again
12
A. Cut the tube straight
across using a suitable
tool (pipe cutter or
cropper).
B. Clean the surface
to be welded and the
adapters with cellulose
tissue dampened with
isopropanol.
C. Mark the length of
the weld on the tube.
tool to the mains
(230V. /50
3.6 3.7
and down 7 arrows
3.4
to confirm the setting.
D. Wait for the temperature to reach the
setting. Approx. 7 minutes up to 260º,
and
stabilize the temperature around the plate.
3. Welding process
A. Heating: apply a slight pressure both to the
tube and the accessory to let the adapters
go into the corresponding tube or accessory
(tube
male adapter) for the time stated in table.
B. Assembly:
accessory from their adapters and introduce
one into the other (NO TURNING) up to
the weld depth mark. This operation must
be done as fast and carefully as possible.
C. Setting and cooling: the time for this last stage
is shown in the table. Make sure no forces
are exerted onto the welding area during this
time. When the time is over, the welded tubes
and the accessories may be used following
tube
4. Weld checking
The weld lip must be uniform over the full rim.
Storage
When the equipment is no longer going to be used,
you are recommended to turn it off and allow it to
cool in order to store it. Store it carefully in a locked,
dry place out of reach of children.
Care and maintenance
Inspect the adapters before using them. Carefully
remove any material remaining from previous
welding operations.
Do not use metallic items or solvents to remove
residues, as these could damage the surface of the
adapter.
PRECAUCION
NOTE
Check the condition of the adapters from time to
time, to ensure correct welding.
or
Hz.).
3.4
ENGLISH
some 15 minutes
to female adapter,
Remove the
manufacturer recommendations.
total time to
accessory to
tube and the