Advanced Programming - Telcoma TANGO Manual De Instrucciones

GB
- Immediately after this the led starts blinking again, waiting for a new
radio control signal to be memorised; if it receives none after blinking
another 5 times, the receiver automatically exits from the program-
ming stage.
Our transmitter and receiver are already operative!
- Follow the same procedure also for the other P keys.
3. Meaning of the blinking LEDs
- L2 on for 3 seconds: as soon as the receiver is powered.
- Brief flash of one led: when transmitting with a correctly memorised
radio control, and the respective relay is activated.
- Simultaneous blinking of all the LEDs: during programming this indi-
cates that a transmitter that is already enabled is being memorised.
- Alternate blinking of the LEDs: during programming this indicates
that the storage is full.

ADVANCED PROGRAMMING

A series of options to operation of the relay output in the receivers are
available, which makes them versatile.
Attention! Do not set options given in this section with button P1 of
the TANGO SR receiver.
1. Single-step output
- During programming press key P2 twice instead of once as described
in paragraph 2 under the heading "Standard programming".
- The led related to the pressed button gives 5
series of two blinks.
- During this stage, transmit with a transmitter
from the TANGO range.
- A fixed led light for a few moments indicates that
30
(P3 - L3)
(P4 - L4)