Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
This mechanism enables the same bends to be reproduced on the electric motor hydraulic benders with cylinder No.2
(240802).
Assembly
Position and attach the collar
Attach the end of run switch
Insert the command rod
Attach the command rod
Mount the setting stop
Remove the cover from the terminal unit
Screw the stuffing box
Cable using
(do not use the blue wire).
Operation
When the setting stop
this point you must set the switch to off and loosen the return knob
piston
to come back in.
WARNING: a prolonged stoppage of the setting stop
USING THE RUN LIMITER 240811
along the plug
to the collar
.
into the collar
.
to the cylinder
piston.
on the command rod
.
.
activates the end of run switch
.
.
, the piston
on the end of run switch
movement is stopped by the motor stopping. At
on the other side of the cylinder to enable the
may damage the motor.
EN
18
Publicidad
Tabla de contenido
