Aqua Medic EcoDrift Wireless Master Manual De Instrucciones página 5

C:
Constant flow.
W1: Frequency and speed can be adjusted. By using the SPEED button, the power can be varied in
steps of 20% between 20 and 100%. By turning the control dial Fig. 2, No. 4) the frequency
can be changed.
W2:
The flow is increased slowly and then decreased just as slowly again.
Random: The flow changes according to the random principle.
10 Min.: If the SPEED/FEED button is pressed for 5 seconds, the LED 10 min. lights up. The pump is
stopped for 10 minutes and then starts again. If you want to start it earlier, press the
SPEED/FEED button again for 5 seconds.
TIMER/LOCK: By briefly pressing, you can change channels (time display in timer, Fig. 2, No. 1) or operate
the unit without channels (- - display in the timer, Fig. 2, No. 1). If the button is held down a
bit longer, the red "Lock" LED will illuminate and the controller (Fig. 2, No. 4) can no longer be
adjusted despite turning it.
+/-:
Set the switch interval of channel A to B. 1 - 60 minutes can be adjusted. Set the pump mode
and speed mode for both channels first without time (display - -), then set the desired time
interval.
Night Mode: After the light sensor has been connected to the EcoDrift Control 0 – 10 V (Fig. 1), the night mode
can be activated by pressing the MODE/NIGHT button on the Wireless Master Controller a bit longer. The night
mode is activated and displayed by a LED (Night). In night mode, at darkness without changing channels, all
pumps with light sensor automatically reduce the power to half power.
To use the night function, the light sensor has to be attached to a lighted place, but not directly at a very bright
light source as this may damage the sensor. The sensor is not encapsulated waterproof. Please protect it from
condensate and respect a maximum of 80% air humidity.
Fig. 2: EcoDrift Wireless Master Controller
1. Switch interval 1 - 60 minutes
2. Pump power 20% steps
3. Connection for 0 - 10 V control
4. Warranty conditions
AB Aqua Medic GmbH grants the first-time user a 24-month guarantee from the date of purchase on all material
and manufacturing defects of the device. Incidentally, the consumer has legal rights; these are not limited by
this warranty. This warranty does not cover user serviceable parts, due to normal wear & tear ie: impellers or
drive wheels etc. The original invoice or receipt is required as proof of purchase. During the warranty period, we
will repair the product for free by installing new or renewed parts. This warranty only covers material and
processing faults that occur when used as intended. It does not apply to damage caused by transport, improper
handling, incorrect installation, negligence, interference or repairs made by unauthorized persons. In case of a
fault with the unit during or after the warranty period, please contact your dealer. All further steps are clarified
between the dealer and AB Aqua Medic. All complaints and returns that are not sent to us via specialist dealers
cannot be processed. AB Aqua Medic is not liable for consequential damages resulting from the use of any of our
products.
AB Aqua Medic GmbH - Gewerbepark 24 - 49143 Bissendorf/Germany
4. Controller
5. Pump mode
6. Channel display
- Technical changes reserved - 03/2019
for pulse frequency
5