Cleaning And Maintenance - Princess 282993 Instrucciones De Uso

THIS APPLIANCE CAN BE USED AS FOLLOWS:
A. In the car:
Connect the DC power cord to DC socket of the fridge and plug it into the cigarette jack in the car. Then
set the selection switch (11) to the DC setting. Select the function by turning the selection switch (10) to
the 'cold' or 'hot' position and turn the fridge on using the ON / OFF switch (12). After using the fridge,
turn it off by turning the ON / OFF switch to the "OFF" position.
B. Indoors:
Connect the AC power cord to the AC socket of the fridge and plug it into the power outlet. Then set the
selection switch (11) to the AC setting. Please check before use that the voltage in your home is the same
as that of the appliance. Select the function by turning the selection switch (10) to the 'cold' or 'hot' posi-
tion and turn the fridge on using the ON / OFF switch (12). After using the fridge, turn it off by turning
the ON / OFF switch to the "OFF" position.

CLEANING AND MAINTENANCE

Turn off the power before you clean the fridge. The appliance can be cleaned easily. The inside of the
appliance can be cleaned with a damp cloth. Be sure that you keep the chill compartment and interior of
the fridge dry. The outside of the appliance can be kept clean by polishing with a soft towel with neutral
cleanser. Be careful not to use solvents!
PRINCESS TIPS
- Never immerse the PRINCESS MINI FRIDGE or power cords in water.
- The fridge only uses DC 12V in the car.
- Do not insert any objects into the evaporation or ventilation holes.
- Do not expose the fridge to direct sunlight.
- Keep the fridge away from sources of heat.
- Avoid spillage in the fridge.
- Unplug the appliance when it is not in use.
- Place the appliance on a stable and even surface.
- Do not use the appliance if it is damaged, or when the power supply cord is damaged, but return it to
the store to be repaired. A damaged cord can only be repaired by the Princess repair service.
- Do not connect the fridge to a 24-Volt battery, or to a power transformer. If using a DC power supply,
this has to be suitable for 4 Amps and the voltage needs to be stabilized at 12 to 14 Volts.
- Children should be supervised to ensure that they do not play with the appliance.
- The use of this appliance by children or persons with a physical, sensory, mental or motorial disability,
or lack of experience and knowledge can give cause to hazards. Persons responsible for their safety
should give explicit instructions or supervise the use of the appliance.
- Foods such as fruits, breads, etc must be wrapped with preservative film or placed on a vessel before
they are placed in the appliance.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the following code:
BLUE
BROWN
As the colours of the wire in the mains lead of this appliance may not correspond with the colour
markings identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked
with the
letter L or coloured red.
WARNING: ON NO ACCOUNT SHOULD EITHER THE LIVE OR
NEUTRAL WIRES BE CONNECTED TO THE EARTH TERMINAL
With this appliance, if a 13 amp plug is used a 3 amp fuse should be fitted. If any other
type of plug is used, a 15 amp fuse must be fitted either in the plug or at the distribution
board.
NEUTRAL
LIVE
6