RAVAK PDOP1 Instrucciones De Montaje página 5

GB
ASSEMBLY INSTRUCTIONS
0. Content of the mounting package.
1. Turning pivot shower door one-part, two-part.
2. Level the fixing profile into a perpendicular line using a water level. Mark the
location of the profiles clearly on the wall.
3. Encircle the holes for mounting.
4. Bore a hole and hammer in a wall plug 8 mm diameter. Beware of the electric
lines, water and gas pipes under the plaster.
5. In the place where will be the entrance of the shower door, screw on the fixing
profile on the wall using screws 4/40 mm.
6. Slide the second fixing profile onto the doorframe.
7. Slide the product into the profile, which is already mounted.
8. Level it as marked on the wall.
9. Stick the screws 4/40 mm through the prebored holes in the doorframe into the
wall plugs and mount the fixing profile onto the wall.
10. Set the doorframe between the mounted profiles in the optimal position.
11. Close the mounting holes in the doorframe with the blind flanges 10/13 mm.
12. Apply a silicone sealant on the seating area of the shower body and the shower
tray. Always fill the gap between the product and the shower tray only from the
outside, fill the vertical gap by the wall in the same way. The areas prepared for
filling must be dry, firm and clean.
13. Complete assembled product.
14. The handle is adjustable.
15. If necessary, it is possible to readjust the turning pivot shower door.
g
16. A,B... F
IMPORTANT!
When maintaining the shower bath, only wipe the painted parts, glass and plastic, using a fine cloth and normal household
detergents. Never use abrasive pastes, solvents, acetones or similar substances. The manufacturer is not responsible for
damage caused by inappropriate use, installation or maintenance of the product. The manufacturer is entitled to continuous
innovation of the product. For all other information concerning the mounting, use and maintenance, ask your salesperson.
We recommend the use of the RAVAK SERIES of speciality chemicals
which perfectly renews and maintains all the qualities of the RAVAK ANTICALC protective coating; RAVAK CLEANER - works
to remove old and dried-on debris from glass surfaces, shower frames, enamel and acrylic bathtubs, washbasins and water
taps; RAVAK DESINFECTANT - is a special preparation with considerable anti-bacterial and anti-fungal effects.
Ecologically dispose of the packaging materials and after the service life of the radiator is finished, properly dispose of the
radiator as well. The reusable parts of the packaging materials such as the carton, tape and PE foil can be reused again
instead of recycling them. The non-recyclable parts of the packaging and later, the radiator itself should be disposed of in
a safe and proper manner according to law. Recycle the metal parts of the radiator by taking it to the proper recycling area.
: RAVAK ANTICALC CONDITIONER - is a preparation
PDOP1 PDOP1
PDOP2 PDOP2