Tabla de contenido
Publicidad
66 |
- Check that the discharging system is working properly.
- Check the ignition and if the flames are normal.
- Train the user on the unit operation and maintenance by
means of the instruction manual. Furthermore, inform
the user about all warnings to be followed in order to
use the unit correctly.
SAFETY DEVICES
A valved tap with thermocouple stops the gas flow to the
main burner in the event that the pilot flame switches off.
To restore the operation, repeat the operations to ignite
the pilot device.
Safety thermostat
Stops the gas flow in the event of serious anomalies. It is
reactivated manually and, to restore it, it is necessary to
unscrew nut "A" (fig. 5). If the safety thermostat starts up, call
BAGNOMARIA
technical assistance.
PEL 25ST
EN
USE INSTRUCTIONS
Posizione
We recommend that the user checks that the installation
is performed properly.
The manufacturer is not responsible for damage due to an
2
incorrect installation, bad maintenance or incorrect use.
3
4
- The appliance is for industrial use and must be used by
trained personnel.
5
- This appliance must be used for the purposes it is
6
designed for. Every other use is incorrect.
7
- Do not use these appliances as fryers because the
oil temperature can not be controlled and it would
overcome 230 °C with the risk of the oil catching on fire.
- Do not use the appliance when the tank is empty.
- Do not modify the combustion aeration system.
- Before running the unit, READ THE INSTRUCTIONS OF
THIS MANUAL CAREFULLY, pay particular attention to
the regulations relevant to safety devices.
- Always Close the gas cocks after use and especially
during the maintenance and repairing operations.
- Follow the cooking regulations carefully at least for the
first period of use until practise and experience will allow
you to choose time and temperature.
- When running the appliance for the first time, clean the
tanks properly and the drilled boards with warm water
and detergent to eliminate the film of protective oil that
covers the tanks.
LOADING THE TANK
Make sure the draining tap is closed. Use the handle of the
loading tap, if any, which is positioned on the left of the
appliance's front panel.
DRAINING THE TANK
Drain the tank by rotating the draining tap knob placed
BAGNOMARIA
PEL 25ST
CUOCIPASTA
Posizione
Gradi °C
PEL 21S
55
Gradi °C
Posizione
2
60
55
3
65
60
4
70
65
5
75
70
6
80
BAGNOMARIA
75
7
85
80
PEL 25ST
90
85
Posizione
90
2
3
4
5
6
7
BAGNOMARIA
PEL 25ST
BAGNOMARIA
Posizione
Gradi °C
PEL 25ST
55
Posizione
Gradi °C
2
60
55
3
65
2
60
4
70
MOD.
inside the cabinet under the combustion chamber. In a few
Qn
models, the draining tap is positioned on the front panel.
V
kW:
Hz: 50/60
Ignition of the pilot burner
Press in and rotate the tap knob anticlockwise over to
the pilot position (
to exit the pipes (only the first time) and them press the
piezoelectric button (
model, hold down the ON button. Though the proper hole
on the front of the combustion camera, make sure that the
pilot flame is ignited. When the flame is switched on, keep
the knob pressed for a few seconds and then release it. If
the flame switches off, repeat the operation.
CUOCIPASTA
NOTE
PEL 21S
In the event of a failure that causes the lack of the spark, the
ignition can be performed manually.
Posizione
Keep the knob pressed in the position (
small flame to the pilot burner by introducing it through the
2
inspection hole of the combustion chamber.
3
2
Pilot burner ignition
4
After switching on the pilot burner flame, turn the knob of
3
5
the tap in the maximum power position (
4
6
the main burner that switches on. To reduce the power of
5
the burner, turn the knob to the minimum position (
7
6
BAIN MARIE
7
PEL 25ST
Gradi °C
Position
Degrees °C
55
55
BAGNOMARIA
2
60
60
PEL 25ST
3
65
BAGNOMARIA
65
4
70
Posizione
Gradi °C
PEL 25ST
70
5
75
55
6
80
75
Posizione
Gradi °C
2
60
7
85
80
55
90
3
65
85
2
60
4
70
90
3
65
5
75
TURNING OFF
4
70
6
80
To turn off the main burner, rotate the tap knob clockwise
5
75
until reaching the position (
7
85
6
80
To turn off the appliance completely, rotate the tap knob
90
clockwise up to the position (
7
85
90
WARNING AND ADVICE
- While cooking with the pasta cooker, keep the water
loading tap a little opened to allow the elimination of
CUOCIPASTA
starch through the overflow and to keep the right level
of water in the tank.
PEL 21S
- NEVER SWITCH ON THE UNIT BEFORE LOADING THE
CUOCIPASTA
TANK WITH WATER.
Posizione
PEL 21S
- During the use, the sides of the appliances can reach
Posizione
2
3
2
4
N°:
IPX
IGNITION
), await the necessary time for air
) several times. For the SG7CP40M
) and bring a
). Gas reaches
CUOCIPASTA
PEL 21S
PASTA COOKER
PEL 21S
Posizione
Position
CUOCIPASTA
2
2
PEL 21S
3
CUOCIPASTA
3
4
Posizione
PEL 21S
4
5
6
5
Posizione
2
7
6
3
7
2
4
3
5
4
6
5
).
7
6
).
7
).
Publicidad
Tabla de contenido
