Maintenance; Cleaning The Housing; Service Department - oventrop OV-DMC 3 Instrucciones De Funcionamiento

Maintenance

10. Maintenance

10.1 Cleaning the housing

CAUTION
Danger of electric shock if liq-
uids penetrate the power supply
f If connected, disconnect the pow-
er supply from the mains plug.
f Contact the Oventrop service
department
NOTICE
Damage to surfaces caused by
aggressive cleaning agents
f Do not use abrasive powders or
cleaning agents which dissolve
plastic when cleaning.
f If required, clean surfaces with
a soft cloth. When dealing with
more severe dirt, moisten the cloth
slightly with water or use a mild
detergent.
32

10.2 Service department

Follow the applicable transport
requirements for LiFEP04 (lithium iron
phosphate) batteries.
Local regulations may prescribe
transport in specially-secured con-
tainers or disposal on site, especially
for damaged batteries.
f Transport the measuring system in its origi-
nal packaging.
f If there is a defect, do not open the
housing. Send the product to the following
address.
f Please send the product to the following
address for manufacturer calibration on a
regular annual basis to ensure failure-free
operation:
Oventrop GmbH & Co. KG
Industriegebiet Nord
Hinterm Gallberg 5
D-59929 Brilon
11. Regulation (EC) No
1907/2006 (REACH)
Information as per Article 33 (1).
- The brass components contain
lead (CAS No.: 7439-92-1, EC
No.: 231-100-4) in a concentration
above 0.1 % weight by weight
(w/w).
- The internal enclosure of the
interfaces in the measuring sensor
contains imidazolidine-2-thione
(CAS No.: 96-45-7, EC No.: 202-
506-9) in a concentration above
0.1 % weight by weight (w/w).
The substances are firmly bound in
the material.
"OV-DMC 3"
106927880-V04.01.2020