Safety Instructions And Precautions - Kinderkraft MINKY Manual De Usuario

Dear customer!
Thank you for choosing a product by Kinderkraft.
Our designs are child-oriented – safety and quality always comes first, stay
comfortable knowing that you have made the best choice.
IMPORTANT - Keep these instructions for future reference.

SAFETY INSTRUCTIONS AND PRECAUTIONS

WARNING!
 Never leave your child unattended.
 Do not use the product when the child can sit unaided
or weighs more than 9 kg.
 This product does not replace a baby crib or bed. If your
child needs to sleep, it should be placed in a suitable crib or bed.
 The product is not designed for a long period of sleep.
 Never use the product on elevated surfaces (e.g. on a table).
 Always use the fastening system (safety harness).
 To avoid injury when folding and unfolding the product, make sure that children
are not in the vicinity.
 Do not allow children to play with the product (it does not apply to toys attached
to the toy bar).
 Do not move or lift the product with the baby inside.
 Never use the baby toy bar as a handle to carry the product.
 Keep the product away from open fire and other heat sources such as electric
heaters, gas heaters, etc.
Do not use the product if any parts are damaged or missing.
Do not use any accessories or spare parts other than those recommended by the
manufacturer.
The adapter used with the swing should be regularly checked for damage to the cord,
plug, housing and other parts. In case of damage to the parts, stop using the adapter.
The swing should only be used with an adapter recommended by the manufacturer.
Safe battery use
Disposable batteries are not suitable for charging. Do not mix different types of
batteries, or new batteries with used ones. Insert the batteries according to their
proper polarity. Dead batteries must be removed from the product. Do not short-
EN
9
circuit power poles. The batteries can be charged only under adult supervision.
Technical specifications:
(
Battery-powered INPUT1): 3 pcs. x C 1.5 V
(
Adapter-powered INPUT2): 5V
Bouncer assembly:
Follow Figures B1-B10.
Start tightening of the cover from the backrest, insert the other part (A3) in the lower
part of the cover (B6). Place the ends of A3 tubes in the holes as shown in Fig. B6.
Push the tube ends in the holes towards the bottom of the seat until properly latched.
Secure the seat cover with the straps located under the seat (B7), and make sure that
the assembly was performed correctly and the whole fits tightly
Fitting or replacing batteries:
In order to install or replace the batteries, remove the locking tab from element A1
using a Phillips screwdriver (one screw) and replace the batteries, placing them
according to their proper polarity.
Swing control:
After installing the batteries or connecting the power supply using the wire provided
(the socket is located (B9) in the connecting point of elements A1, A7 and A8), press 1
to start the mechanism (D4 LED will go on). To start the rocking function, press 5.
Press several times more to change the rocking intensity, which is signalled by LEDs D5
to D7. Holding down button 5 will stop the rocking function. To start the music
function, press 2. To change the melody, press 4 (8 options). To change the volume,
press and hold down button 4, and release the button when the volume is satisfactory.
To turn off the sound, press 2 again. To start the time switch, press 3. By pressing this
button you may change the timer setting (D1 – 10 min., D2 – 20 min., D3 – 30 min.) or
switch off the function.
Maintenance and cleaning
Material cover with pillow: Remove from the frame (remove the toy bar, loosen Velcro
strap on the bottom, remove the cover first from the seat, and then from the backrest,
EN
(not included)
, 2A
10