Operating Instructions; Switch Module Ms - HumanTechnik MS-1 Instrucciones De Servicio

We would like to congratulate you
on the purchase of our Switch
Module MS-1 and hope that it will
serve you well for a long time to
come. You have chosen a modern
and reliable system. Please read the
operating instruction through
carefully to be able to start the unit
correctly and to familiarize yourself
with all of the system features.
With the Switch Module MS-1 you
can extend every unit that has a
connector socket (3.5 mm jack) for
the vibrating pillow with a 230 V
switched socket.
Standard components
Please check if all following compo-
nents are included:

- Switch Module MS-1

- Connecting cable
- Operating instruction
- Warranty card
If any parts are missing please
immediately contact your dealer or
the manufacturer directly.
Installation
Attach the connecting cable to one
of the two connector sockets for the
signal source at the back of the
Switch Module MS-1 . Plug the other
end of the cable into a unit with a
connector socket for a vibrating pil-
low (e.g. vibrating clock VC-10, table
flash lamp).
Plug the plug of the Switch Module
MS-1 into a 230 V mains socket and
a lamp into the switched socket of
the module. Please make sure that
the lamp is switched on.
The lamp can be switched on and off
with the switch at the front of the
Switch Module MS-1 .
Note
A vibrating pillow or another
Module (e.g. Flash Module) can be
plugged into the empty connector
socket at the back of the Switch
Module MS-1 .
Signalling
Upcoming signals (e.g. wake-up
alarm, lisa alarm) are signalled by
the lamp being switched on and off.
English 7