Makita PW5001C Manual De Instrucciones página 5

kickback or torque reaction during start-up.
The operator can control torque reactions or
kickback forces, if proper precautions are taken.
b) Never place your hand near the rotating
accessory. Accessory may kickback over your
hand.
c) Do not position your body in the area where
power tool will move if kickback occurs.
Kickback will propel the tool in direction opposite to
the wheel's movement at the point of snagging.
d) Use special care when working corners,
sharp edges etc. Avoid bouncing and snagging
the accessory. Corners, sharp edges or bouncing
have a tendency to snag the rotating accessory
and cause loss of control or kickback.
e) Do not attach a saw chain woodcarving
blade or toothed saw blade. Such blades create
frequent kickback and loss of control.
Safety Warnings Specific for Stone Polishing
Operations:
a) Do not use excessively oversized abrasive
disc. Follow manufacturers recommendations,
when selecting abrasive disc. Larger abrasive
disc extending beyond the pad presents a
laceration hazard and may cause snagging,
tearing of the disc or kickback.
Additional safety warnings:
15. Ground Fault
protection should be provided on the circuit(s)
or outlet(s)
Receptacles are available having built-in GFCI
protection and may be used for this measure
of safety.
16. For additional protection against electric
shock, be sure to WEAR RUBBER GLOVES
AND RUBBER BOOTS during operation.
17. When using the water feed, be careful not to
let water get into the motor. If water runs into
the motor, an electric shock hazard may
result.
18. PROPER GROUNDING. This tool should be
grounding while in use to protect the operator
from electric shock.
19. EXTENSION CORDS. Use only three-wire
extension cords which have three-prong
grounding-type
receptacles which accept the tool's plug.
Replace or repair damaged or worn cord
immediately.
20. Make sure the abrasive disc is not contacting
the workpiece before the switch is turned on.
21. Do not leave the tool running. Operate the tool
only when hand-held.
22. Check that
supported.
Circuit Interrupter
to be used for
plugs and
the workpiece is
23. Pay attention that the wheel continues to
rotate after the tool is switched off.
24. Do not use the tool on any materials
containing asbestos.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
(GFCI)
the tool.
three-pole
properly
5
･
volts
･
amperes
･
hertz
･
alternating current
･
rated speed
･
no load speed
･
revolutions or reciprocation per minute
USD210-1