Tamper Protection; System Reset - Velleman CTC1000KP Manual Del Usuario

Send keypad learn signal
Enable dual-key panic alarm
Enable dual-key fire alarm
Enable dual-key medical alarm
Disable dual key
Enable arm/ home without pin
code
Enable arm/ home with pin
code
Quit test mode
Notes
 When the keypad is in test mode, the power saving feature does
not apply.
 If no key is pressed within 30 minutes, the keypad will return to
normal operation mode.

12. Tamper protection

 The keypad is protected against any attempt to open the lid or to
detach the keypad from its mounting surface.
 Tamper protection is disabled when in test mode.
 When a keypad tamper is triggered, it will send a signal to the
control panel and the orange LED will turn on. In addition, while
using the keypad, orange LED will stay on to indicate the kp
tamper fault.

13. System reset

 If you have forgotten the pin code or anything happened in the
keypad, you can reset the keypad to factory default.
 After reset, the PIN code reverts to its factory default (0000).
 After reset, you will need to set up the connection between the
keypad and the control panel.
To reset the keypad:
1. Remove the keypad from the wall.
2. Remove one of the batteries and release the tamper switch.
V. 01 – 12/06/2013
CTC1000KP
Press ＊ and then 1
Press ＊ and then 2
Press ＊ and then 3
Press ＊ and then 4
Press ＊ and then 5
Press ＊ and then 8
Press ＊ and then 9
Press
10
twice.
©Velleman nv